M.A. Ford
M.A. Ford CXDCS 0660AP Cyclone Xd 6.60mm drill
Coolant-fed double-margin drill, 6.60 mm diameter, for high-efficiency chip evacuation
- 60 mm diameter matches precise drilling needs
- Coolant-fed design removes heat for longer tool life
- Double-margin construction improves hole straightness and finish
- Cyclone Xd geometry reduces cutting forces for smoother operation
- California Proposition 65 notice informs safe handling practices
6.60 mm Coolant-Fed Drill
The M.A. Ford CXDCS 0660AP Cyclone Xd is a 6.60 mm solid-carbide drill with internal coolant delivery and a double-margin design. It is built for machine shops running CNC equipment that can supply through-spindle coolant. The tool targets production drilling in steel, stainless alloys and high-temperature metals where chip evacuation and hole straightness are critical.
3×D Coolant Channel and Double Margins
Internal coolant passages feed cutting fluid directly to the point, reducing heat at the drill tip and flushing chips from deep holes. The double-margin geometry adds a second land that guides the drill, improving roundness and surface finish while reducing wander on cross-holes or angled entries. These features replace the need for peck cycles in many 3× diameter depths.
Standard Shank Fits Common Holders
The drill uses a standard cylindrical shank compatible with hydraulic, shrink-fit and collet chucks found in most CNC shops. No special adapters or programmable coolant rings are required beyond through-spindle capability. Common issues arise when coolant pressure is too low to clear chips at full feed or when the holder run-out exceeds the drill’s tight tolerance, leading to premature margin wear.
Highlights
- 60 mm diameter matches precise drilling needs
- Coolant-fed design removes heat for longer tool life
- Double-margin construction improves hole straightness and finish
- Cyclone Xd geometry reduces cutting forces for smoother operation
- California Proposition 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
When should the 6.60 mm double-margin drill be resharpened or replaced?
Inspect the cutting edges regularly; resharpen when flank wear reaches the manufacturer's recommended limit, and replace if the coolant-fed channels show blockage or margin damage that cannot be restored.
What limits continuous drilling depth with the 3X coolant-fed design?
The 3X diameter flute length sets the practical deep-hole limit; chip evacuation and coolant pressure must be maintained to avoid packing beyond that depth.
How much heat and noise does the CXDCS 0660AP generate during all-day CNC cycles?
Heat is managed by the internal coolant feed through the 6.60 mm body, keeping the cutting zone cool; noise level matches typical carbide drill operation in a guarded machine enclosure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
