M.A. Ford
M.A. Ford CXDCS 0430AP Cyclone Xd 4.30mm drill
Coolant-fed double-margin drill with 4.30 mm diameter for precise, high-speed drilling
- 30 mm diameter fits precise drilling tasks
- Double margin design improves hole straightness and finish
- Coolant-fed construction extends tool life in tough materials
- Cyclone Xd geometry boosts chip evacuation efficiency
- California Proposition 65 compliance noted for user safety awareness
4.30 mm Cyclone Xd drill for precision drilling
This M.A. Ford CXDCS 0430AP Cyclone Xd drill is a 4.30 mm coolant-fed, double-margin tool built for accurate holemaking in demanding materials. It suits machinists and fabricators who need consistent diameter control and straightness on CNC or dedicated drilling machines.
Sustained performance
Internal coolant delivery flushes chips from the cutting zone during deep or continuous cuts, reducing heat buildup at the margins. The double-margin design maintains alignment over long engagements, limiting drift and preserving finish quality when the drill runs at production feed rates.
Check machine coolant and holder compatibility
Verify that your spindle or turret supplies coolant through the tool at the pressure and flow your process requires. Confirm the shank style matches your toolholder — collet, hydraulic or shrink-fit — so the drill seats concentrically. Ensure workpiece clamping is rigid enough for the thrust loads a 4.30 mm drill generates at full engagement.
Highlights
- 30 mm diameter fits precise drilling tasks
- Double margin design improves hole straightness and finish
- Coolant-fed construction extends tool life in tough materials
- Cyclone Xd geometry boosts chip evacuation efficiency
- California Proposition 65 compliance noted for user safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 4.30 mm drill run hot or draw high power when used continuously?
The Cyclone Xd drill is a solid carbide cutting tool with no motor or electronics, so it produces no heat or power draw of its own; thermal load depends on the machine spindle and cutting parameters you set.
What toolholder or machine interface is needed to run this 4.30 mm drill?
The drill has a straight cylindrical shank designed for coolant-fed holders such as hydraulic chucks, shrink-fit holders or Weldon flats that can supply through-tool coolant at 3X pressure.
Will the 4.30 mm Cyclone Xd drill work in an older CNC with only external flood coolant?
The drill is engineered for through-spindle coolant delivery at 3X pressure; without that internal coolant path chip evacuation and tool life will be reduced on an older flood-only machine.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
