M.A. Ford
M.A. Ford CXDCR 1930AP Cyclone Xd 19.30 mm Power Drill
A 19.30 mm coolant-fed double-margin drill built for 5× diameter depth holes
- 30 mm diameter matches precise hole specs
- 5X coolant-fed design clears chips efficiently
- Double-margin geometry improves hole straightness
- Cyclone Xd coating resists wear longer
- New condition ensures full factory performance
19.30 mm Cyclone Xd drill
The M.A. Ford CXDCR 1930AP is a 19.30 mm diameter Cyclone Xd drill designed for production drilling in metal. It targets machine shops and fabricators who need a coolant-fed tool for deep-hole accuracy. The 5× diameter capability suits extended reach requirements in tough alloys.
Coolant-fed double-margin build
Coolant channels run through the tool body to deliver lubricant directly to the cutting zone, reducing heat and improving chip evacuation. The double-margin design adds a second guiding land that stabilises the drill in the hole, helping maintain straightness and surface finish on long passes. This construction supports repeatable results in automated cells.
5× diameter depth constraint
The drill is rated for a 5× diameter drilling depth, limiting practical hole depth to roughly five times the 19.30 mm diameter. Deeper holes would require a different length series or a pecking cycle not covered by this tool’s geometry. Users must also verify machine spindle coolant delivery and holder compatibility before use.
Highlights
- 30 mm diameter matches precise hole specs
- 5X coolant-fed design clears chips efficiently
- Double-margin geometry improves hole straightness
- Cyclone Xd coating resists wear longer
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank standard does the 19.30 mm Cyclone Xd drill use for coolant-fed tool holders?
The drill uses a standard cylindrical shank with internal coolant channels that match 5×D coolant-fed holders for the 19.30 mm diameter.
What machine spindle and holder clearance does the 19.30 mm double-margin body require?
The 19.30 mm cutting diameter needs a holder bore and spindle clearance sized for 19.30 mm plus the double-margin width; verify the holder ID before mounting.
How is the coolant-fed drill installed and what alignment step is often missed?
Insert the shank fully into the coolant-fed holder, torque the clamping nut to the holder maker's spec, then confirm coolant flows through both margins before starting the spindle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
