M.A. Ford
M.A. Ford CXDCR 1916AP 5X Coolant Fed Double Margin Drill 19.16mm
A 19.16 mm diameter coolant-fed double-margin drill designed for 5× depth drilling operations
- 5× coolant-fed drilling depth for efficient chip removal
- double margin design improves hole straightness and finish
- 16 mm diameter suits precise machining tasks
- Cyclone XD series built for high-performance drilling
- California Proposition 65 warnings indicate chemical hazards
19.16 mm Coolant-Fed Drill
The M.A. Ford CXDCR 1916AP is a 5X diameter Cyclone XD drill with double margins and internal coolant feed. It is engineered for production drilling in steel and cast iron where hole straightness and finish are critical.
Deep-Hole Chip Control
Through-tool coolant flushes chips from the flutes during extended cycles, preventing packing at full 5X depth. The double-margin design stabilises the drill in the hole, reducing wander and maintaining diameter tolerance over long cuts.
Machine-Ready Shank
The straight shank fits standard hydraulic or shrink-fit holders without adapters. Coolant passages must align with the holder’s ports; misalignment blocks flow and causes premature wear. Proposition 65 warnings apply to the coating.
Highlights
- 5× coolant-fed drilling depth for efficient chip removal
- double margin design improves hole straightness and finish
- 16 mm diameter suits precise machining tasks
- Cyclone XD series built for high-performance drilling
- California Proposition 65 warnings indicate chemical hazards
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 19.16 mm drill generate noticeable heat or noise when running continuously?
The CXDCR 1916AP is a solid carbide cutting tool with no motor or fan, so it produces no electrical noise; heat comes only from the cutting zone and is managed by the 5X coolant-fed channels.
What tool holder or machine spindle is required to run the 19.16 mm double-margin drill?
A rigid CNC machine or drill press with through-spindle coolant capability and a collet or hydraulic chuck that accepts a 19.16 mm shank is needed.
Can the 19.16 mm Cyclone Xd drill be used in an older manual drill press without through-coolant?
It will cut, but the 5X coolant-fed design relies on high-pressure internal coolant for chip evacuation and tool life; running dry on a manual press will reduce performance and may damage the drill.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
