M.A. Ford
M.A. Ford CXDCR 1283AP Cyclone Xd 12.83mm Coolant Fed Double Margin Drill
A 12.83 mm coolant-fed double-margin drill designed for 5× diameter drilling depth
- 83 mm diameter drills precise holes in tough materials
- Coolant-fed design removes heat for longer tool life
- Double-margin geometry improves hole straightness and finish
- Cyclone Xd series built for high-performance drilling applications
- New M.A. Ford cutter ready for immediate workshop use
CXDCR 1283AP Cyclone Xd Drill
The M.A. Ford CXDCR 1283AP is a 12.83mm coolant fed double margin drill designed for precision holemaking. It belongs to the Cyclone Xd series built for high performance drilling applications. This cutting tool targets machinists and engineers requiring accurate diameter control. The 5X design supports deeper hole capabilities in a single pass.
Suited for high precision drilling
This drill suits professionals producing accurate holes in demanding materials where coolant delivery improves tool life. The double margin geometry enhances stability and hole finish quality. Buyers needing non coolant fed tooling or different diameter sizes should look at other options. It is not intended for general purpose hand drilling tasks.
12.83mm diameter capacity
The 12.83mm diameter handles specific hole size requirements with consistent precision. Coolant fed operation manages heat effectively during deep drilling cycles. Double margins provide guidance that maintains straightness through the cut. The tool reaches its limit when hole diameters or material conditions fall outside its design parameters.
Highlights
- 83 mm diameter drills precise holes in tough materials
- Coolant-fed design removes heat for longer tool life
- Double-margin geometry improves hole straightness and finish
- Cyclone Xd series built for high-performance drilling applications
- New M.A. Ford cutter ready for immediate workshop use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle is required to hold the 12.83 mm shank of this drill?
A CNC machining centre or rigid milling machine with a 12.83 mm capacity collet or hydraulic chuck is needed to secure the shank and deliver the 5×D coolant-fed drilling cycle.
Can the CXDCR 1283AP be used in a conventional drill press without through-spindle coolant?
No; the double-margin design and 5×D length rely on high-pressure through-tool coolant for chip evacuation and heat control, so a standard drill press without coolant feed will not perform reliably.
How can I verify the drill is cutting correctly after installation?
Check for consistent chip formation, steady spindle load, hole diameter within tolerance at 12.83 mm, and no discoloration on the double margins after the first few holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
