M.A. Ford
M.A. Ford CXDCR 1100AP 11.00 mm coolant-fed double-margin drill
Coolant-fed 11.00 mm double-margin drill for high-precision holemaking
- 00 mm diameter drills precise holes
- Coolant-fed design removes heat during deep cuts
- Double-margin construction keeps the drill running straight
- Cyclone Xd 5X geometry improves chip evacuation
- New condition ensures full cutting performance
11 mm coolant-fed drill for deep-hole precision
The M.A. Ford CXDCR 1100AP is a Cyclone Xd 5X drill with a 11.00 mm diameter, designed for coolant-fed double-margin drilling. It targets machinists who need straight, accurate holes in demanding materials where chip evacuation and tool life are critical.
Thermals managed by through-tool coolant delivery
Coolant flows directly to the cutting zone through the tool body, controlling heat at the interface during extended cuts. The double-margin design stabilises the drill in the hole, reducing vibration that can increase power draw and acoustic signature in normal operation.
Double-margin geometry improves hole quality
Two lands guide the drill for better roundness and surface finish while the coolant-fed construction implies compatibility with machines equipped for through-spindle or through-holder delivery. Buyers without high-pressure coolant capability or needing non-coolant drills should consider other options.
Highlights
- 00 mm diameter drills precise holes
- Coolant-fed design removes heat during deep cuts
- Double-margin construction keeps the drill running straight
- Cyclone Xd 5X geometry improves chip evacuation
- New condition ensures full cutting performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 11.00 mm coolant-fed drill and what step is often missed?
Mount the CXDCR 1100AP in a holder with internal coolant delivery, set the 5×D depth, and ensure the double-margin lands engage fully before applying feed; the step most often missed is verifying coolant pressure at the spindle.
What maintenance or replacement will the 11.00 mm double-margin drill need later?
Inspect the two margin lands for wear after each job; when the margin width drops below specification or chipping appears on the cutting edges, replace the CXDCR 1100AP drill.
What limit appears first on the 11.00 mm coolant-fed drill under sustained use?
Margin-land wear and heat buildup at the cutting edges become the limiting factor during prolonged drilling; maintain correct coolant flow and reduce feed if temperatures rise.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
