M.A. Ford
M.A. Ford CXDCR 1050AP 10.50mm Cyclone Xd 5X Coolant Fed Double Margin Drill
A 10.50 mm Cyclone Xd 5X coolant-fed double-margin drill for deep-hole drilling
- 50 mm diameter suits precise hole sizing
- 5X coolant-fed design improves chip evacuation
- Double-margin geometry enhances hole straightness
- Cyclone Xd coating reduces cutting friction
- M.A. Ford manufacturing ensures consistent quality
10.50 mm Cyclone Xd drill overview
The M.A. Ford CXDCR 1050AP is a 10.50 mm solid-carbide drill built for high-performance holemaking. Its Cyclone Xd geometry and double-margin design deliver superior hole quality and tool life in demanding materials. The 5× diameter coolant-fed configuration suits production environments that require deep, accurate holes. Machinists and job-shop operators gain a reliable tool for consistent results.
Sustained-load behaviour with coolant feed
Through-tool coolant evacuates chips efficiently during extended drilling cycles, preventing packing and thermal damage at depth. The double-margin construction stabilises the drill under continuous side loads, maintaining diameter tolerance and surface finish. Cyclone Xd flute geometry reduces cutting forces, allowing higher feed rates without premature wear. This combination supports predictable performance in long production runs.
Compatibility checks before ordering
Verify that your machine spindle and holder accommodate a 10.50 mm shank with through-coolant capability. Confirm the workpiece material matches the drill’s recommended application range for carbide tooling. Ensure your coolant system delivers sufficient pressure and filtration for deep-hole drilling. California Proposition 65 warnings apply; review safety data sheets for handling requirements.
Highlights
- 50 mm diameter suits precise hole sizing
- 5X coolant-fed design improves chip evacuation
- Double-margin geometry enhances hole straightness
- Cyclone Xd coating reduces cutting friction
- M.A. Ford manufacturing ensures consistent quality
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the CXDCR 1050AP generate during continuous drilling?
The drill body is designed for through‑coolant flow, which carries heat away from the cutting zone and keeps the tool temperature stable during long cycles.
What machine setup is required to use the coolant‑fed feature?
A spindle or holder with internal coolant passages and a compatible coolant supply system are needed to deliver fluid through the drill.
Will the 10.50 mm shank fit my older tool holders?
The shank diameter matches standard 10.50 mm holder bores, so existing collets or hydraulic chucks of that size will accept it directly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
