M.A. Ford
M.A. Ford CXDCR 0850AP Cyclone Xd 5X Coolant Fed Drill 8.50 mm
Coolant-fed double-margin drill with 5× diameter depth capacity for 8.50 mm holes
- 50 mm diameter drills precise holes in metal
- 5X coolant-fed design clears chips from deep bores
- Double-margin geometry keeps the cut straight and round
- Cyclone Xd coating resists wear on tough alloys
- New M.A. Ford drill ready for production use
Cyclone Xd 5X Coolant-Fed Drill
The M.A. Ford CXDCR 0850AP is a solid-carbide drill with an 8.50 mm diameter and a 5×D flute length. It targets machine shops that need accurate holes in steel, stainless steel or high-temperature alloys. The double-margin design improves hole straightness and surface finish on CNC centres with through-spindle coolant.
8.50 mm Diameter and 5×D Reach
This size covers a common bolt-hole range in aerospace and automotive components. The 5×D flute length provides enough chip clearance for medium-depth holes without peck cycles. It runs out when hole depth exceeds five times the diameter or when the machine lacks sufficient coolant pressure to evacuate chips from deeper cuts.
Double-Margin Geometry and Coolant Feed
Two margins guide the drill continuously, reducing walk and improving roundness compared with single-margin tools. Internal coolant channels deliver fluid to the cutting lips, extending tool life and allowing higher feed rates in difficult alloys. The coating withstands the heat generated at elevated speeds.
Highlights
- 50 mm diameter drills precise holes in metal
- 5X coolant-fed design clears chips from deep bores
- Double-margin geometry keeps the cut straight and round
- Cyclone Xd coating resists wear on tough alloys
- New M.A. Ford drill ready for production use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 8.50 mm Cyclone Xd drill work with my existing 5X coolant delivery system?
The drill is designed for 5X coolant-fed operation and has an 8.50 mm diameter, so it matches systems built for that size and pressure specification.
How can I verify the double-margin drill is cutting correctly after installation?
Check for consistent chip evacuation through the coolant holes and measure hole diameter against the 8.50 mm specification during the first test cuts.
Does the CXDCR 0850AP come with any collets or coolant fittings in the box?
The product ships as the drill body only; collets, holders and coolant fittings must be sourced separately to match your machine interface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
