M.A. Ford
M.A. Ford CXDCR 0630AP 5X Coolant Fed Double Margin Drill 6.30 mm
A 6.30 mm coolant-fed double-margin drill designed for 5x diameter drilling depth
- 5× coolant-fed drilling depth for efficient chip removal
- Double-margin design improves hole straightness and surface finish
- 30 mm diameter suits precise metric hole-making
- Cyclone XD geometry optimised for high-performance drilling
- California Proposition 65 chemical warning applies to this product
CXDCR 0630AP Cyclone XD Drill
The M.A. Ford CXDCR 0630AP is a 6.30 mm diameter coolant-fed double margin drill designed for production drilling operations. It targets machinists and manufacturers who require precise holemaking with internal coolant delivery in demanding materials.
Installing the 5X coolant-fed drill
Installation requires a machine spindle and tool holder compatible with through-coolant supply to activate the internal channels. The double margin design improves guidance but demands accurate run-out alignment; improper holder seating or insufficient coolant pressure typically causes premature margin wear or hole deviation.
Sustained load behaviour of the double margin drill
Under continuous cutting the internal coolant flow evacuates chips from deep holes while cooling the twin margins to maintain diameter stability. The 5X length-to-diameter ratio supports extended reach, yet sustained feed rates must match coolant capacity to avoid thermal buildup at the cutting edges.
Highlights
- 5× coolant-fed drilling depth for efficient chip removal
- Double-margin design improves hole straightness and surface finish
- 30 mm diameter suits precise metric hole-making
- Cyclone XD geometry optimised for high-performance drilling
- California Proposition 65 chemical warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I confirm the 6.30 mm CXDCR 0630AP is drilling true after setup?
Check hole diameter and straightness with a gauge; the double-margin design should produce consistent 6.30 mm holes at 5× depth when coolant flows steadily.
What comes with the CXDCR 0630AP and what must I supply?
The drill itself is included; you must provide a compatible coolant-fed tool holder, coolant supply, and a machine spindle that accepts the shank.
Which CXDCR version should I choose for a 6.30 mm hole?
Select the 0630AP variant — it is the 6.30 mm diameter, 5× coolant-fed double-margin model in the Cyclone Xd range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
