M.A. Ford
M.A. Ford CDACRM1100 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
Cyclone drill designed for aluminum with 5X reach, two flutes and coolant feed
- Designed for aluminium with 5× flute geometry
- Two-flute layout improves chip evacuation
- Coolant-fed design supports consistent cutting performance
- M.A. Ford engineering for reliable drilling results
- California Proposition 65 warning applies to this product
Cyclone Drill for Aluminium 5X 2 Flute
This M.A. Ford CDACRM1100 drill is engineered for aluminium machining with a five-times-diameter reach and two-flute geometry. Coolant-fed design directs fluid through the tool to the cutting zone. It suits CNC operators and job shops that need deep-hole capability in non-ferrous materials.
Coolant-fed flutes and extended reach
Internal coolant channels evacuate chips from deep holes while reducing heat at the cutting edges. The two-flute layout provides ample chip space for aluminium's long, stringy swarf. Together these features extend tool life and maintain hole straightness at 5X depth.
Check spindle coolant and holder clearance
Verify that your machine spindle and tool holder support through-coolant delivery at the required pressure. Confirm the holder provides enough gauge length for the 5X reach without interference. Ensure your workholding can accommodate the drill's overall length during deep-hole cycles.
Highlights
- Designed for aluminium with 5× flute geometry
- Two-flute layout improves chip evacuation
- Coolant-fed design supports consistent cutting performance
- M.A. Ford engineering for reliable drilling results
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How often will the cutting edges on this 5X 2 flute drill need resharpening?
Resharpening frequency depends on the aluminium alloy and feed rates used; the coolant-fed design helps maintain edge life by reducing heat at the cutting zone.
What limits continuous drilling depth with the 1100 series cyclone drill?
The 5X diameter-to-length ratio sets the maximum hole depth in a single pass; chip evacuation through the coolant channels remains effective up to that limit.
Does the coolant-fed 1100 drill run hot or loud during all-day production?
Internal coolant delivery keeps the cutting zone cool and suppresses vibration, so the tool runs quietly and at low temperature even during extended shifts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
