M.A. Ford
M.A. Ford CDACRM1050 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A coolant-fed cyclone drill for aluminium with two flutes and 5X reach
- Optimised for aluminium with a 5×D reach
- Two-flute geometry improves chip evacuation in soft metals
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series engineering targets high-speed aluminium drilling
- New condition ensures full factory performance from first use
Cyclone Drill for Aluminium
The M.A. Ford CDACRM1050 is a 5X diameter carbide drill with two flutes and through-coolant delivery. It is engineered for high-performance drilling in aluminium and other non-ferrous materials where chip evacuation and heat control are critical. The design targets machine shops and production cells that need consistent hole quality at elevated feed rates.
Suited for CNC aluminium work
This tool suits operators running rigid CNC machines with through-spindle coolant capability who drill deep holes in wrought or cast aluminium. It is not for manual drilling, handheld tools or machines without coolant pressure. Buyers who need to drill steel, titanium or hardened alloys should select a different geometry and coating optimised for those materials.
5X diameter with coolant feed
The defining specification is the 5X length-to-diameter ratio combined with internal coolant channels. This pairing enables deep-hole drilling in a single pass while flushing chips and managing temperature in aluminium. If the application requires a shorter 3X tool or lacks through-coolant supply, this drill will not perform as intended.
Highlights
- Optimised for aluminium with a 5×D reach
- Two-flute geometry improves chip evacuation in soft metals
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series engineering targets high-speed aluminium drilling
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank style does the CDACRM1050 need in my tool holder?
The drill uses a standard cylindrical shank that fits common ER collets, Weldon flats or hydraulic chucks sized for the tool diameter.
Will the 5× length reach through my existing fixture clamps?
The 5× flute length extends the cutting zone well beyond typical clamp heights, so the flutes stay clear of the workpiece face.
How do I confirm coolant is reaching the tip on the CDACRM1050?
Watch for a steady stream exiting the two flute holes at the point; pressure should match the machine spec for 5× carbide drills.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
