M.A. Ford
M.A. Ford CDACRM1010 Cyclone Aluminium 5X 2 Flute Coolant Fed Drill
A 5× diameter, two-flute coolant-fed drill for aluminium machining, model CDACRM1010
- Cyclone design optimised for aluminium machining
- 5X diameter reach for deeper holes
- Two-flute geometry improves chip evacuation
- Coolant-fed delivery reduces heat buildup
- New M.A. Ford drill ready for use
Aluminium drilling specialist
The CDACRM1010 is a coolant-fed drill engineered for aluminium work. Its two-flute geometry and five-times-diameter reach suit production shops that need straight, deep holes without peck cycles. Buyers who need a general-purpose twist drill for steel or composite stacks will not find the flute design optimised for those materials.
Coolant-fed geometry
Internal coolant passages deliver lubricant directly to the cutting zone. This reduces built-up edge on aluminium and evacuates chips from deep holes. The feature does not replace external flood coolant on machines without through-spindle supply, and it adds no benefit when drilling dry.
Five-times-diameter reach
The 1010 designation reflects a 5×D drilling depth capability. This covers typical aerospace bracket and heat-sink thicknesses in a single pass. Workpieces thicker than that envelope, or interrupted cuts requiring extra rigidity, exceed the tool's intended range. P65 warning applies.
Highlights
- Cyclone design optimised for aluminium machining
- 5X diameter reach for deeper holes
- Two-flute geometry improves chip evacuation
- Coolant-fed delivery reduces heat buildup
- New M.A. Ford drill ready for use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
When will the 2-flute coolant-fed drill need re-sharpening or replacement?
The 2-flute design with internal coolant feed reduces heat during aluminium drilling, extending edge life; re-sharpen or replace once flank wear reaches the manufacturer's recommended limit for the CDACRM1010.
What limits continuous drilling depth in a single pass?
The 5× diameter flute length sets the maximum uninterrupted drilling depth before chip evacuation requires a peck cycle on the CDACRM1010.
How much heat and noise does the cyclone drill generate during all-day aluminium runs?
Internal coolant delivery through the 2 flutes carries heat away from the cutting zone, keeping the CDACRM1010 cooler and quieter than non-coolant-fed drills in sustained aluminium work.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
