M.A. Ford
M.A. Ford CDACRM0970 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A five-times-diameter, two-flute cyclone drill with internal coolant feed for aluminium machining
- Designed for aluminium machining with 5X flute geometry
- Two-flute construction improves chip evacuation during high-speed drilling
- Coolant-fed design delivers fluid directly to the cutting zone
- Built by M.A. Ford for professional workshop reliability
- California Proposition 65 warning applies to this product
Aluminium Drilling Specialist
The M.A. Ford CDACRM0970 Cyclone Drill is engineered specifically for aluminium workpieces. Its 5X diameter configuration and two-flute geometry target machinists and fabricators who need efficient chip evacuation in non-ferrous metals. The coolant-fed design supports sustained cutting performance during production runs.
Coolant-Fed Installation Notes
Fitting this drill requires a machine spindle equipped for through-coolant delivery and a compatible tool holder. The two-flute layout reduces clogging risk, yet incorrect coolant pressure or misaligned holders can still cause premature wear. Operators should verify spindle runout before starting a job.
Best For High-Volume Aluminium
Shops running repeated aluminium drilling cycles will benefit from the specialised flute profile and internal cooling. The tool is less suited for one-off maintenance tasks, mixed-material setups, or machines without through-spindle coolant capability. Buyers needing broader material coverage should evaluate general-purpose alternatives.
Highlights
- Designed for aluminium machining with 5X flute geometry
- Two-flute construction improves chip evacuation during high-speed drilling
- Coolant-fed design delivers fluid directly to the cutting zone
- Built by M.A. Ford for professional workshop reliability
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I verify the CDACRM0970 Cyclone Drill is cutting aluminum correctly after setup?
Check for smooth, consistent chip evacuation through the coolant-fed channels and a clean hole finish without built-up edge on the 2-flute design.
What comes with the CDACRM0970 drill and what must I supply separately?
The drill itself is included; you will need a compatible coolant-fed tool holder and coolant system for through-tool delivery.
Which CDACRM0970 version should I choose for 5× diameter depth holes in aluminum?
The CDACRM0970 is a 5×D, 2-flute, coolant-fed model designed specifically for that depth range in aluminum.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
