M.A. Ford
M.A. Ford CDACRM0870 Cyclone Drill for Aluminum 5x 2 Flute Coolant Fed
Coolant-fed drill with two flutes designed for aluminium, supplied in a pack of five
- Designed for aluminium machining with 5x diameter reach
- Two-flute geometry clears chips efficiently in non-ferrous metals
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series optimised for high-speed drilling applications
- California Proposition 65 warning applies to this product
M.A. Ford Cyclone Drill for Aluminum
The M.A. Ford CDACRM0870 Cyclone Drill is built for aluminum machining with a 5x length and two flutes. Coolant-fed design helps clear chips and control temperature during deep-hole work. New condition ensures full tool life from the first cut. Suited for CNC and manual operations that demand reach and chip evacuation.
Best for deep aluminum holes with through-coolant
Shops drilling aluminum at 5x diameter depth will benefit from the flute geometry and internal coolant path. Operations without through-spindle coolant cannot use the feed feature and should look elsewhere. Buyers needing carbide grades for steel, titanium or hardened alloys must select a different tool. The Prop 65 notice also applies for California compliance.
Sustained cutting with coolant flow
Under continuous load the two flutes and coolant channel work together to evacuate chips and reduce heat buildup. Steady coolant pressure maintains consistent chip removal at depth without peck cycles. Tool life remains stable when feed and speed match aluminum parameters. Overheating risk drops compared with non-coolant drills at the same 5x depth.
Highlights
- Designed for aluminium machining with 5x diameter reach
- Two-flute geometry clears chips efficiently in non-ferrous metals
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series optimised for high-speed drilling applications
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle is required to run the CDACRM0870 cyclone drill?
The drill is a coolant-fed cutting tool designed for use in a CNC machining centre or similar spindle that supplies internal coolant through the tool holder.
Will the 5× diameter flute length reach through a thick aluminium plate on my older mill?
The 5× flute length provides extended reach for deep-hole drilling in aluminium, provided your mill has sufficient Z-axis travel and rigidity to support the overhang.
How can I confirm the CDACRM0870 is cutting correctly after installation?
Check for consistent chip evacuation through the coolant holes, a smooth hole surface finish, and stable spindle load without chatter during the drilling cycle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
