M.A. Ford
M.A. Ford CDACRM0730 Cyclone Aluminum Drill 5X 2 Flute Coolant Fed
A 5× diameter, two-flute coolant-fed drill built for aluminium machining
- Cyclone design optimised for aluminium machining
- 5× diameter drilling depth in single pass
- Two-flute geometry improves chip evacuation
- Coolant-fed operation reduces heat buildup
- New condition ensures full tool life
Aluminium Drill For CNC Use
The M.A. Ford CDACRM0730 Cyclone drill is engineered for high-performance drilling in aluminium. Its 5X diameter geometry and two-flute design suit production environments where chip evacuation and hole quality are critical. This new tool targets machinists who need reliable coolant-fed operation.
Coolant-Fed Geometry For Chip Control
Internal coolant channels deliver fluid directly to the cutting zone, reducing heat buildup and improving chip evacuation in deep holes. The 5X length-to-diameter ratio supports deeper drilling without peck cycles, freeing up machine time. Operators must provide a compatible coolant-through spindle or holder.
Proposition 65 Compliance Notice
The product carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm. Safe handling procedures and personal protective equipment are required during use and disposal. No additional accessories or software are bundled with this drill.
Highlights
- Cyclone design optimised for aluminium machining
- 5× diameter drilling depth in single pass
- Two-flute geometry improves chip evacuation
- Coolant-fed operation reduces heat buildup
- New condition ensures full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the CDACRM0730 drill before chip evacuation becomes the limiting factor?
The 5× diameter design allows drilling to five times the tool diameter before chip packing typically limits further progress.
Does the coolant-fed design keep the shank temperature low during continuous aluminum drilling?
Internal coolant channels deliver fluid directly to the cutting zone, reducing heat buildup on the shank during extended runs.
What machine spindle interface is required to run this cyclone drill?
A coolant-through spindle with compatible tool-holder clamping is needed to supply cutting fluid through the drill body.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
