M.A. Ford
M.A. Ford CDACRM0650 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A coolant-fed cyclone drill with two flutes designed for aluminium at five times the diameter
- Optimised for aluminium with a Cyclone drill design
- 5× diameter reach extends deep-hole capability
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed operation reduces heat buildup during extended cuts
- California Proposition 65 warning indicates regulated chemical content
Cyclone Drill for Aluminium
The M.A. Ford CDACRM0650 Cyclone Drill is a coolant-fed cutting tool designed for aluminium machining. Its 2-flute geometry and 5x diameter length support deeper holes with efficient chip evacuation. The drill targets workshops and production cells that need reliable performance in non-ferrous materials.
Suited for aluminium work, not steel
This drill suits operators running aluminium alloys where through-coolant delivery improves tool life and hole quality. It is not for buyers who need a drill for steel, stainless steel or cast iron. It is also not for buyers who want a solid drill without internal coolant passages or a different flute count.
Check machine coolant and holder fit
Verify that your machine spindle and tool holder can deliver coolant through the tool at the required pressure. Confirm the shank style matches your holder type before ordering. Ensure the workpiece clamping allows the full 5x drilling depth without interference.
Highlights
- Optimised for aluminium with a Cyclone drill design
- 5× diameter reach extends deep-hole capability
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed operation reduces heat buildup during extended cuts
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle is required for the 650 coolant-fed shank?
The drill has a 650 shank designed for coolant-through spindles, so your machine must supply internal coolant at the spindle interface.
Can the 65 mm flute length reach full depth in a 50 mm thick aluminium plate?
Yes, the 65 mm flute length exceeds a 50 mm plate thickness, allowing full penetration with the two-flute geometry.
How do I confirm coolant is flowing through the drill after installation?
Start the spindle at low speed with coolant on; a steady stream from the two flute exits shows the internal passages are clear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
