M.A. Ford
M.A. Ford CDACRM0620 Cyclone Drill for Aluminum 5X 2 Flute Coolant Fed
Drills aluminium efficiently with a 5x diameter reach, two-flute design and through-coolant feed
- Designed for aluminium with 5X diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M.A. Ford quality built for professional workshop use
- California Proposition 65 warning applies to this product
Cyclone Drill for Aluminum 5X
The M.A. Ford CDACRM0620 Cyclone Drill is a coolant-fed cutting tool built for high-efficiency aluminium machining. Its two-flute geometry and 5× diameter reach suit CNC operators and job-shop technicians who need deep-hole capability in non-ferrous materials. The design targets chip evacuation and heat control in production environments.
5× reach with coolant feed
The 5× length-to-diameter ratio provides extended reach for deep features while the internal coolant channel delivers fluid directly to the cutting zone. This combination supports higher feed rates and longer tool life in aluminium alloys, though the two-flute layout limits chip space in extremely deep or high-volume roughing passes where a three-flute design would offer more clearance.
Upgrade from standard twist drills
Shops moving from conventional external-coolant twist drills gain deeper straight holes and reduced peck cycles on vertical and horizontal machining centres. The step is worthwhile when hole depth exceeds three diameters and coolant-through spindle capability exists; it is not for manual drilling, handheld tools, or materials other than aluminium.
Highlights
- Designed for aluminium with 5X diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M.A. Ford quality built for professional workshop use
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 5X flute length work with my existing toolholder and spindle setup?
The drill has a 5X flute design and coolant-fed construction, so verify your toolholder accommodates the flute length and your spindle delivers coolant through the tool.
How can I confirm the coolant-fed channels are flowing properly after installation?
Run a test cycle with coolant on and watch for steady flow from the drill tip; consistent chip evacuation and hole quality indicate the internal passages are clear.
Does the CDACRM0620 come with any collets, clamps or coolant adapters in the package?
Only the cyclone drill itself is supplied; collets, clamping hardware and any required coolant adapters must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
