M.A. Ford
M.A. Ford CDACRM0610 Cyclone drill for aluminum 5X 2 flute coolant fed
A 5X 2-flute coolant-fed Cyclone drill designed for aluminum machining
- Cyclone geometry cuts aluminium cleanly
- 5× diameter reach for deep holes
- Two-flute design evacuates chips efficiently
- Coolant-fed channels reduce heat build-up
- M.A. Ford quality for reliable performance
M.A. Ford Cyclone Drill for Aluminium
The M.A. Ford CDACRM0610 Cyclone drill is a coolant-fed cutting tool designed specifically for aluminium. Its two-flute geometry and 5X capability support efficient chip evacuation during deep-hole drilling operations. This new power-tool accessory targets machinists and fabricators who need reliable performance in non-ferrous materials. The drill suits high-volume production environments where consistent hole quality matters.
Suited for aluminium-focused machining.
This drill suits workshops that primarily machine aluminium and want a dedicated, coolant-fed solution for 5X depth holes. Buyers who need a single drill for steel, titanium or hardened alloys should look elsewhere because the geometry is optimised for non-ferrous work only. Shops without through-spindle coolant capability cannot use the internal coolant channels as intended. The two-flute design also limits its appeal for applications demanding three or more flutes.
Verify coolant delivery and holder compatibility
Before ordering, confirm that your machine spindle and tool holder support through-coolant delivery at the pressure your aluminium process requires. Check that the holder accepts the drill shank style and that your workholding provides enough rigidity for 5X depth drilling. Ensure your CAM post-processor can generate the correct peck or continuous cycles for a two-flute, coolant-fed tool in aluminium.
Highlights
- Cyclone geometry cuts aluminium cleanly
- 5× diameter reach for deep holes
- Two-flute design evacuates chips efficiently
- Coolant-fed channels reduce heat build-up
- M.A. Ford quality for reliable performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle or tool holder do I need to run the M.A. Ford CDACRM0610 Cyclone drill?
The drill is a coolant-fed solid-carbide tool, so it requires a machine spindle with through-coolant capability and a compatible holder such as a hydraulic chuck, shrink-fit holder or high-precision collet chuck that can deliver coolant through the tool.
Can I use the CDACRM0610 alongside older high-speed steel drills in the same aluminium job?
Yes, but the Cyclone drill runs at much higher speeds and feeds with through-coolant, so you must adjust the programme for each tool; mixing them without changing parameters will give poor results.
How can I confirm the CDACRM0610 is performing correctly after setup?
Check for consistent chip formation, steady spindle load, proper coolant flow through the tool and hole diameter within tolerance; these indicate the 5×D coolant-fed drill is cutting as designed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
