M.A. Ford
M.A. Ford CDACRM0510 Cyclone Drill for Aluminum 5X 2 Flute Coolant Fed
Coolant-fed cyclone drill cuts aluminium at 5× diameter with two flutes
- Designed for aluminum machining with 5X diameter capability
- Two-flute geometry improves chip evacuation in non-ferrous materials
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series engineered for high-performance drilling applications
- California Proposition 65 compliance noted for regulated substances
M.A. Ford Cyclone Drill for Aluminum
The M.A. Ford CDACRM0510 Cyclone Drill is a coolant-fed cutting tool engineered specifically for aluminium workpieces. Its two-flute geometry and 5X diameter capability support deeper holes with consistent chip evacuation. This new drill suits machine shops and fabricators who need reliable performance in non-ferrous metals.
Suited for aluminium drilling
This drill serves operators running CNC or manual machines equipped with through-spindle coolant delivery. It is not intended for users without coolant-fed capability, for general-purpose drilling in steel or cast iron, or for applications requiring a different flute count or length ratio than the 5X specification provides.
5X diameter depth with two-flute coolant-fed design
The defining specification is the 5X diameter drilling depth combined with a two-flute, coolant-fed construction. This pairing determines whether the tool reaches the required hole depth while managing heat and chips in aluminium. Verify that your machine and holder match these parameters before purchase.
Highlights
- Designed for aluminum machining with 5X diameter capability
- Two-flute geometry improves chip evacuation in non-ferrous materials
- Coolant-fed design delivers fluid directly to the cutting zone
- Cyclone series engineered for high-performance drilling applications
- California Proposition 65 compliance noted for regulated substances
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 5X flute design drill before chip evacuation becomes the limiting factor?
The 5X flute length allows drilling up to five times the diameter in aluminium before chips must be cleared.
Does the coolant-fed shank stay cool enough for continuous CNC cycles without overheating the holder?
Internal coolant delivery flushes heat from the cutting zone, keeping the shank and holder stable during extended runs.
Will the 510 shank fit my existing ER collet or do I need a specific coolant-compatible holder?
The 510 shank requires a coolant-through holder or collet with sealed nut; standard ER collets will not seal the feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
