M.A. Ford
M.A. Ford CDACRM0480 Cyclone Aluminum 5X Drill 2 Flute Coolant Fed
A coolant-fed, two-flute Cyclone drill designed for aluminium with 5X capability
- Designed for aluminium machining with Cyclone 5X geometry
- Two-flute design improves chip evacuation in non-ferrous metals
- Coolant-fed operation reduces heat build-up during deep holes
- New condition ensures full factory performance from first use
- California Proposition 65 warning applies to this product
Application Fit
The M.A. Ford CDACRM0480 Cyclone drill is designed for aluminum machining with a 5X flute length and coolant-fed delivery. Its two-flute geometry supports chip evacuation in non-ferrous materials. The tool arrives new and ships directly from the manufacturer.
Who It Serves
Machinists producing aluminum components benefit from the coolant-fed design and extended flute reach. Buyers working with steel, titanium or other ferrous alloys should select a different tool. Shops without through-spindle coolant capability cannot use the internal feed feature.
Deciding Specification
The 5X flute length determines the maximum drilling depth in a single pass. California Proposition 65 notices apply: the product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Highlights
- Designed for aluminium machining with Cyclone 5X geometry
- Two-flute design improves chip evacuation in non-ferrous metals
- Coolant-fed operation reduces heat build-up during deep holes
- New condition ensures full factory performance from first use
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter and length does the CDACRM0480 require for a 5×D coolant-fed setup?
The drill is built for a 5× diameter depth with internal coolant delivery through the shank; match your holder to the shank size shown on the tool drawing.
Which step do users miss when installing a 2-flute Cyclone drill for aluminium?
They often forget to verify that the machine’s through-spindle coolant is active and filtered before the first plunge; dry entry chips the cutting edges instantly.
How often should the CDACRM0480 be re-ground or replaced in high-volume aluminium work?
Plan on re-grinding after the flank wear reaches the maker’s limit — typically every few thousand holes — and keep a spare 480-series tool on hand for change-over.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
