M.A. Ford
M.A. Ford CDACRM0320 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed Drill
A coolant-fed drill with two flutes designed for aluminium at 5x diameter depth
- Optimised for aluminium with Cyclone geometry
- 5x diameter reach extends drilling depth
- Two-flute design improves chip evacuation
- Coolant-fed operation reduces heat buildup
- New condition ensures full factory performance
Aluminium 5X Coolant-Fed Drill
The M.A. Ford CDACRM0320 is a solid-carbide Cyclone drill built for aluminium and non-ferrous alloys. Its 5 × diameter flute length and twin-flute geometry suit production runs where chip evacuation and hole straightness are critical. Machinists running high-speed centres gain a tool that reduces peck cycles and holds tolerance in soft, gummy material.
Coolant Channels and Flute Design
Internal coolant passages deliver lubricant to the cutting zone, suppressing built-up edge and extending tool life in deep holes. The two wide flutes evacuate long aluminium chips without packing, so the spindle stays loaded and surface finish stays consistent. Shops avoid the downtime of clearing jammed flutes on conventional drills.
Proposition 65 Compliance Notice
The product carries California Proposition 65 warnings for chemicals linked to cancer and reproductive harm. Buyers must follow their facility safety programme: use coolant mist extraction, wear appropriate PPE and store the tool per SDS guidelines. No additional coatings, software or accessories are bundled with the drill.
Highlights
- Optimised for aluminium with Cyclone geometry
- 5x diameter reach extends drilling depth
- Two-flute design improves chip evacuation
- Coolant-fed operation reduces heat buildup
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What does the 5X designation mean for this Cyclone drill?
The 5X indicates a five-times-diameter drilling depth capability for efficient aluminum holemaking.
What shank style does the CDACRM0320 use for tool-holder mounting?
It features a standard cylindrical shank designed for direct collet or hydraulic holder clamping.
How should the coolant-fed channels be primed before the first cut?
Run the machine's coolant pump at low pressure to purge air from the internal passages before engaging the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
