M.A. Ford
M.A. Ford CDACR3438 Cyclone Drill for Aluminum 5X 2 Flute Coolant Fed
Cyclone drill for aluminium with 5x diameter reach, two flutes and coolant feed
- Designed for aluminium with 5× diameter drilling depth
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford Cyclone series built for high-speed production
- California Proposition 65 warning: contains listed chemicals
Cyclone Drill for Aluminum
The M.A. Ford CDACR3438 Cyclone Drill is a coolant-fed cutting tool designed for aluminium work. Its two-flute geometry and 5X length suit production drilling where chip evacuation and hole depth matter. Machinists running CNC or dedicated drill presses use it for consistent results in non-ferrous alloys. The drill arrives new and ships directly from the manufacturer.
Coolant-fed drilling limits
Coolant-fed operation requires a machine spindle and holder that deliver fluid through the tool centre. Without through-coolant capability the drill cannot clear chips from deep holes effectively. The 5X length amplifies this need; inadequate coolant pressure or volume leads to packing and premature wear. Shops without through-spindle coolant should select a different tool.
5X length-to-diameter ratio
The 5X ratio defines the maximum practical hole depth relative to the drill diameter. It sets the reach for deep-hole aluminium jobs but demands rigid setups and precise Peck cycles to avoid deflection. Buyers needing deeper holes must evaluate longer ratios, while those drilling shallow features gain no advantage from the extra length.
Highlights
- Designed for aluminium with 5× diameter drilling depth
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford Cyclone series built for high-speed production
- California Proposition 65 warning: contains listed chemicals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Which length and flute option should I pick for the CDACR3438 Cyclone Drill?
The CDACR3438 is a single 5X 2-flute coolant-fed drill; no alternative lengths or flute counts are offered for this model.
How does the 5X coolant-fed design perform when drilling aluminium on a CNC machine?
The 5X length-to-diameter ratio with through-coolant delivery clears chips efficiently and maintains hole straightness in deep aluminium drilling operations.
What shank standard does the CDACR3438 use and what holder does it require?
It uses a standard cylindrical shank compatible with ER collets, hydraulic chucks or shrink-fit holders for secure, run-out-controlled clamping.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
