M.A. Ford
M.A. Ford CDACR2720 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A 5× diameter coolant-fed drill with two flutes for aluminium machining
- Optimised for aluminium machining with Cyclone geometry
- 5× diameter reach for deeper holes in one pass
- Two-flute design improves chip evacuation in soft alloys
- Coolant-fed channels deliver fluid directly to the cutting zone
- California Proposition 65 warning: contains listed chemicals
Cyclone Drill for Aluminium
The M.A. Ford CDACR2720 is a coolant-fed drill built for aluminium machining. Its two-flute geometry and five-times-diameter reach suit production runs where chip evacuation and hole depth matter. Machinists working on CNC centres or dedicated drilling units will find it matches high-speed aluminium workflows.
Coolant-fed drilling limits
Through-tool coolant improves chip removal and temperature control in deep holes, but the machine must supply adequate pressure and filtration. If the spindle or coolant system cannot deliver consistent flow, the drill cannot reach its intended depth or surface finish. Workshops without through-spindle coolant cannot use this tool as designed.
5× diameter reach decides fit
The 5X length-to-diameter ratio defines the maximum hole depth this drill can achieve in a single pass. Buyers needing deeper holes without pecking or a longer flute length must select a different tool. Shops drilling only shallow holes gain no advantage from the extra length and rigidity penalty.
Highlights
- Optimised for aluminium machining with Cyclone geometry
- 5× diameter reach for deeper holes in one pass
- Two-flute design improves chip evacuation in soft alloys
- Coolant-fed channels deliver fluid directly to the cutting zone
- California Proposition 65 warning: contains listed chemicals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Which diameter should I pick for the M.A. Ford CDACR2720 Cyclone Drill?
The CDACR2720 is a single part number; choose it when your job calls for a 5× diameter coolant-fed drill for aluminium.
What does the 5X designation mean when the drill is in the machine?
It indicates the flute length is five times the drill diameter, giving deeper hole capability in aluminium without pecking.
How does the coolant-fed design affect chip evacuation?
Internal coolant channels flush chips from the two flutes, reducing heat and improving finish in aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
