M.A. Ford
M.A. Ford CDACR2031 Cyclone Aluminium 5X 2 Flute Coolant Drill
A 5× diameter coolant-fed drill with two flutes for aluminium, model 2031
- Designed for aluminium with 5x diameter reach
- Two-flute geometry improves chip evacuation in soft metal
- Coolant-fed design reduces heat during deep holes
- New condition ensures full factory performance
- California Proposition 65 warning applies to this item
M.A. Ford Cyclone Aluminium Drill
The M.A. Ford CDACR2031 is a coolant-fed drill built for aluminium machining. Its 5× diameter length and two-flute geometry suit production runs where chip evacuation and hole accuracy matter. Machinists working on CNC centres or dedicated drilling units will find it matches high-speed aluminium workflows.
Coolant-Fed Two-Flute Design
Internal coolant delivery flushes chips from deep holes without peck cycles, cutting cycle time on 5× depth holes. The two-flute layout balances chip space and core strength so the drill resists deflection in soft, gummy aluminium alloys. Operators see straighter holes and longer tool life versus external-coolant drills.
Solid Carbide Build Quality
Solid carbide construction holds edge sharpness through abrasive aluminium-silicon alloys. The shank fits standard hydraulic or shrink-fit holders for run-out below five microns. No flats or whistle-notch features are present, so collet clamping must be uniform. The tool carries a Proposition 65 warning for chemicals known to California to cause cancer and reproductive harm.
Highlights
- Designed for aluminium with 5x diameter reach
- Two-flute geometry improves chip evacuation in soft metal
- Coolant-fed design reduces heat during deep holes
- New condition ensures full factory performance
- California Proposition 65 warning applies to this item
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How often should the coolant-fed channels on the CDACR2031 be flushed to prevent clogging?
Flush the coolant passages after each extended drilling session to clear aluminium chips and residue, then inspect the two flute openings for blockage before the next use.
What wear limit appears first when running the Cyclone drill continuously in aluminium?
The cutting edges on the two flutes dull before the shank or coolant ports show wear, so monitor hole quality and replace the drill when edge rounding reduces chip evacuation.
How much heat builds up in the CDACR2031 during all-day production drilling?
The internal coolant feed carries heat away from the cutting zone, keeping the tool body near ambient temperature even during sustained high-speed operation in aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
