M.A. Ford
M.A. Ford CDACR1470 Cyclone Drill for Aluminum 5X 2 Flute Coolant Fed
Cyclone drill cuts aluminium five times diameter with two flutes and coolant feed
- 5x diameter reach for deeper aluminium holes
- 2-flute geometry clears chips efficiently
- Coolant-fed design reduces heat buildup
- Cyclone series optimised for aluminium alloys
- M.A. Ford quality for reliable performance
Cyclone Drill for Aluminum 5X
The M.A. Ford CDACR1470 is a coolant-fed drill engineered specifically for aluminium workpieces. Its two-flute geometry supports 5× diameter drilling depth in a single pass. The tool targets machine shops and fabricators who need consistent chip evacuation in non-ferrous metals.
Replaces standard twist drills without
Conventional drills rely on external flood coolant that often fails to reach the cutting zone in deep holes. This design delivers lubricant directly to the tip, reducing built-up edge and extending tool life. The upgrade pays off when hole depth exceeds three diameters or when cycle time must drop.
Sustained load keeps cutting edges cool
Continuous internal coolant flow stabilises temperature during long production runs, preventing the thermal cycling that cracks carbide. Flutes stay clear because chips are flushed forward under pressure rather than packing in the helix. The result is repeatable hole size and surface finish from the first part to the last.
Highlights
- 5x diameter reach for deeper aluminium holes
- 2-flute geometry clears chips efficiently
- Coolant-fed design reduces heat buildup
- Cyclone series optimised for aluminium alloys
- M.A. Ford quality for reliable performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the CDACR1470 require for a secure fit in the holder?
The drill uses a standard shank that matches common 5X holders for aluminum work.
Which step is most often missed when installing the coolant-fed CDACR1470?
Connect the coolant line before tightening the holder so the internal channels stay clear.
When should the CDACR1470 be replaced to maintain hole quality in aluminum?
Replace it once flank wear reaches the limit for 5X drilling or if coolant flow drops.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
