M.A. Ford
M.A. Ford 305M0086 Twister Micro-Tuff Drill 0.86mm pneumatic accessory
A 0.86 mm Twister Micro-Tuff drill bit designed for precision pneumatic drilling applications
- Precision drilling with 0.86 mm Twister Micro-Tuff bit
- Durable Micro-Tuff construction for extended tool life
- M.A. Ford quality in power and pneumatic accessories
- California Prop 65 chemical warning for cancer risk
- California Prop 65 warning for reproductive harm risk
Twister Micro-Tuff Drill 0.86 mm
This new M.A. Ford Twister Micro-Tuff drill bit is sized at 0.86 mm for fine drilling tasks. It belongs to the Power & Pneumatic Accessories category and is supplied as a pneumatic accessory. The part number is 305M0086.
Build quality and shank fit
The drill carries the Micro-Tuff designation from M.A. Ford, indicating a construction intended for precision work. Its shank dimensions suit standard collets or chucks used with pneumatic handpieces, so it installs without adapters. Daily use involves securing the bit, running the tool, and replacing the bit when wear appears.
Practical limits of the 0.86 mm diameter
At 0.86 mm the drill removes very little material per pass, so feed rates must stay low to avoid breakage. The small diameter also limits hole depth to what the flute length can clear. California Proposition 65 warnings note that the product contains chemicals known to cause cancer and birth defects or other reproductive harm.
Highlights
- Precision drilling with 0.86 mm Twister Micro-Tuff bit
- Durable Micro-Tuff construction for extended tool life
- M.A. Ford quality in power and pneumatic accessories
- California Prop 65 chemical warning for cancer risk
- California Prop 65 warning for reproductive harm risk
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank standard does the 0.86 mm Twister Micro-Tuff drill use, and what chuck capacity does that limit it to?
The drill has a straight 0.86 mm shank, so it fits any drill chuck or collet that closes down to 0.86 mm or smaller.
What physical clearance does the 305M0086 need to fit inside a machine or fixture?
The tool is a 0.86 mm diameter micro drill; allow at least that diameter plus the flute length for hole depth and chip evacuation.
How is the 0.86 mm Twister Micro-Tuff drill installed, and what step do users often miss?
Insert the straight shank fully into a clean, correctly sized collet or chuck and tighten evenly; the common mistake is clamping on the flutes instead of the shank.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
