M.A. Ford
M.A. Ford 305M0028 Twister Micro-Tuff Drill 0.28mm pneumatic accessory
A 0.28 mm Twister Micro-Tuff drill bit for precision pneumatic drilling tasks
- Precision drilling with 0.28 mm micro diameter
- Twister Micro-Tuff design for high-speed performance
- M.A. Ford quality for professional applications
- Pneumatic accessory compatible with power tools
- California Proposition 65 compliance disclosure included
Micro-Tuff Drill 0.28 mm
The M.A. Ford 305M0028 Twister Micro-Tuff Drill is a pneumatic accessory manufactured for precision hole-making at a diameter of 0.28 mm. It is intended for machinists and technicians who require a small-diameter cutting tool driven by compressed air.
Prop 65 chemical notice
This product carries a California Proposition 65 warning because it contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. Users should follow applicable safety guidelines and wear appropriate personal protective equipment when operating the accessory.
0.28 mm cutting diameter
The single specification that determines suitability is the 0.28 mm drill diameter; the accessory only produces holes of this exact size. Buyers who need a different hole diameter must select another tool.
Highlights
- Precision drilling with 0.28 mm micro diameter
- Twister Micro-Tuff design for high-speed performance
- M.A. Ford quality for professional applications
- Pneumatic accessory compatible with power tools
- California Proposition 65 compliance disclosure included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 0.28 mm Twister Micro-Tuff drill use?
The drill measures 0.28 mm in diameter, so it requires a collet or chuck that can grip that exact size.
What collet or chuck capacity is needed to hold this 0.28 mm drill?
A precision collet or micro-chuck rated for 0.28 mm is required; standard 3 mm or 1/8 in collets will not close far enough.
How is this micro drill installed in a pneumatic tool, and what step is often missed?
Insert the 0.28 mm shank fully into the collet, then tighten evenly; the common error is leaving a gap that lets the bit walk under load.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
