M.A. Ford
M.A. Ford 30023440 Twister GP 5X drill 15/64 straight shank
A 15/64 inch straight-shank Twister GP 5X drill bit for general-purpose drilling
- Twister GP 5X geometry drills five diameters deep in one pass
- 15/64 inch straight shank fits standard drill chucks without adapters
- M.A. Ford cutting-tool heritage backs consistent hole quality
- California Proposition 65 notice flags chemical content for user awareness
- Manufacturer-direct supply chain simplifies replacement ordering
Twister GP 5X drill 15/64
The M.A. Ford 30023440 Twister GP 5X drill is a straight-shank cutting tool sized at 15/64 inch. It is built for machinists and maintenance crews who need a reliable general-purpose drill bit for everyday metalwork.
Check shank fit and material
Verify that your drill press or hand drill accepts a straight shank of this diameter. Confirm the workpiece material suits a general-purpose geometry and that your coolant or lubrication setup matches the application. Review the Proposition 65 notice for chemical safety awareness.
Fits standard chucks frees specialty bits
The straight shank seats directly in standard three-jaw chucks without adapters, leaving collets and reduced-shank holders free for larger diameters. Its 15/64 size bridges common fractional steps, reducing the need to switch between finer increments during a job.
Highlights
- Twister GP 5X geometry drills five diameters deep in one pass
- 15/64 inch straight shank fits standard drill chucks without adapters
- M.A. Ford cutting-tool heritage backs consistent hole quality
- California Proposition 65 notice flags chemical content for user awareness
- Manufacturer-direct supply chain simplifies replacement ordering
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the M.A. Ford 30023440 Twister GP 5X drill include any accessories or only the bit itself?
The listing describes a single 15/64 straight-shank drill bit; no case, driver or extra bits are mentioned.
How do I decide between the 15/64 size and another diameter for my job?
Choose 15/64 when the hole must be exactly that fraction; select a different diameter only if the drawing or fastener calls for another size.
What does the 5X designation mean when the drill is in a hand drill or press?
5X indicates a flute length roughly five times the 15/64 diameter, giving deeper holes per plunge than shorter series bits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
