M.A. Ford
M.A. Ford 30008460 Twister Gp 5X Straight Shank Drill 2.15 mm
Twister Gp 5X straight-shank drill with a 2.15 mm diameter for precision drilling tasks
- Precision 2.15 mm drilling with Twister Gp 5X geometry
- Straight shank fits standard chucks without adapters
- M.A. Ford industrial-grade cutting performance
- California Prop 65 chemical disclosure included
- New condition ready for immediate workshop use
2.15 mm Twister GP 5X Drill
The M.A. Ford 30008460 is a 2.15 mm straight-shank drill from the Twister GP 5X line. It is built for metal-cutting tasks where a rigid, short flute and precise diameter are required. The tool suits machinists and maintenance crews who need a single-size drill ready for immediate use.
Upgrade from general-purpose twist drills
Standard high-speed steel bits tend to walk on hard alloys and wear quickly at the corner. The Twister GP 5X geometry reduces thrust and improves chip evacuation, so the step up pays off when hole count or material hardness makes re-sharpening intervals too short. If your work stays in soft wood or plastic, the extra capability is not needed.
Capacity and headroom
The 2.15 mm diameter handles pilot holes, clearance holes and tapping prep in steel, stainless and cast iron within the drill's flute length. It runs out when the application demands a larger diameter, deeper holes than the flute allows, or a coolant-through shank for high-volume production.
Highlights
- Precision 2.15 mm drilling with Twister Gp 5X geometry
- Straight shank fits standard chucks without adapters
- M.A. Ford industrial-grade cutting performance
- California Prop 65 chemical disclosure included
- New condition ready for immediate workshop use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 2.15 mm Twister Gp 5X drill need to fit my chuck?
The drill has a straight shank matching its 2.15 mm diameter, so it fits any chuck that accepts a 2.15 mm round shank.
How do I install the 30008460 drill bit without it slipping?
Open the chuck fully, insert the straight shank until it seats, then tighten evenly; the step most people skip is checking that the bit runs true before drilling.
When will the 2.15 mm Twister Gp 5X drill need replacement?
Replace it when the cutting lips show visible wear, chipping, or when the bit no longer cuts cleanly at the proper feed rate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
