M.A. Ford
M.A. Ford 2XDCE4375A Twister Xd Drill 12X-25X Coolant Fed 11.11mm
Coolant-fed drill operates at 12 to 25 times diameter with an 11.11 mm cutting diameter
- Twister Xd design handles 12X-25X drilling depths
- Coolant-fed operation improves chip evacuation and tool life
- Precise 11.11mm diameter ensures accurate hole sizing
- M.A. Ford quality delivers reliable performance in demanding applications
- California Proposition 65 compliance discloses chemical safety information
M.A. Ford Twister XD Drill 11.11mm
This M.A. Ford Twister XD drill is a coolant-fed cutting tool built for deep-hole drilling at 12X to 25X diameter depths. It serves machinists and maintenance teams who need accurate, straight holes in steel, stainless alloys and cast iron without peck cycles.
Thermals noise and power in normal use
Coolant fed through the tool body removes heat directly from the cutting zone, keeping the drill tip and workpiece cooler during extended cycles. This reduces thermal expansion and allows consistent feed rates while the machine spindle handles power demand.
What the coolant feed changes
Through-tool coolant delivery clears chips from deep flutes, preventing packing that can break the drill or wander the hole. It enables the 12X to 25X depth range in a single pass, cutting cycle time and improving hole straightness compared with external flood coolant.
Highlights
- Twister Xd design handles 12X-25X drilling depths
- Coolant-fed operation improves chip evacuation and tool life
- Precise 11.11mm diameter ensures accurate hole sizing
- M.A. Ford quality delivers reliable performance in demanding applications
- California Proposition 65 compliance discloses chemical safety information
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 11.11mm Twister Xd drill in a coolant-fed holder without misaligning the through-tool channels?
Clamp the shank in a matched coolant-fed holder, align the internal coolant ports with the machine spindle feed, then torque the holder to the machine-builder specification; the step most often missed is verifying port alignment before tightening.
What maintenance will the 12X-25X coolant-fed drill need after extended use?
Inspect the 11.11mm cutting edges for wear, flush the internal coolant passages with solvent after each shift, and re-grind the point geometry on a CNC grinder when flank wear reaches the shop limit.
What limit appears first when running the 12X-25X drill continuously in deep holes?
Chip evacuation through the 11.11mm flutes becomes the limiting factor; coolant pressure must stay high enough to clear chips before they pack and overheat the cutting lips.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
