M.A. Ford
M.A. Ford 2XDCE4252A Twister Xd Drill 12X-25X Coolant Fed 10.80Mm
A 10.80 mm drill with 12X-25X reach and coolant feed for deep-hole drilling
- Drills 12X to 25X diameter depth with coolant feed
- 80 mm diameter suits precise hole-making
- Twister XD design optimises chip evacuation
- M.A. Ford manufacturing ensures professional-grade durability
- California Proposition 65 warning informs safe handling
10.80 mm Twister XD drill for deep holes
The M.A. Ford 2XDCE4252A is a coolant-fed drill built for 12X to 25X diameter depths in a single pass. It targets machinists who need straight, accurate holes without pecking cycles in steel, stainless or high-temperature alloys.
Sustained cutting with through-coolant delivery
Internal channels feed coolant directly to the cutting edges, evacuating chips and controlling heat during long, uninterrupted cuts. The design maintains consistent diameter and finish at full depth, reducing the risk of work hardening or tool breakage in deep-hole applications.
Standard shank fits common holders
The drill uses a conventional shank that mounts in hydraulic, shrink-fit or collet holders without adapters. Problems usually arise when coolant pressure is too low to clear chips at 25X depth or when the workpiece setup lacks rigidity, causing deflection and premature wear.
Highlights
- Drills 12X to 25X diameter depth with coolant feed
- 80 mm diameter suits precise hole-making
- Twister XD design optimises chip evacuation
- M.A. Ford manufacturing ensures professional-grade durability
- California Proposition 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat or noise does the 10.80 mm Twister Xd produce during extended drilling?
The drill is designed for continuous coolant-fed operation, so cutting fluid carries away most heat and keeps sound levels typical for a carbide drill of this size.
What holder or machine setup is required for the 12X-25X coolant-fed shank?
A rigid tool holder with through-coolant capability and a spindle that accepts a 10.80 mm shank is needed to supply coolant at the correct pressure.
Will the 4252 series Twister Xd work in an older CNC that only has flood coolant?
No, the drill requires through-spindle coolant delivery; flood coolant cannot reach the cutting zone at the 12X-25X depth ratio.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
