M.A. Ford
M.A. Ford 2XDCE4055A Twister Xd Drill 12X-25X Coolant Fed 10.30mm
Twister XD drill with 12X to 25X coolant-fed operation for 10.30 mm holes
- Drill up to 12X-25X diameter depth with coolant-fed design
- Precise 10.30mm cutting diameter for accurate hole sizing
- M.A. Ford Twister XD geometry optimised for demanding drilling applications
- Coolant-fed operation reduces heat buildup during extended drilling cycles
- California Proposition 65 compliance noted for chemical safety awareness
Twister Xd Drill 10.30mm
The M.A. Ford Twister Xd Drill is a solid-carbide tool built for high-performance drilling in a single 10.30mm diameter. Its 12X to 25X length-to-diameter range supports deep-hole work without pecking cycles. Internal coolant channels deliver fluid directly to the cutting zone for chip evacuation and temperature control. This drill targets machine shops and production cells that need consistent hole quality in tough materials.
Suited for deep-hole CNC runs
Shops running unattended or lights-out cycles will benefit from the coolant-fed design and extended reach capability. The tool handles stainless steels, high-temp alloys and hardened steels where chip control is critical. Operators without through-spindle coolant or high-pressure pump capacity should look elsewhere. Manual drilling stations and low-rigidity setups cannot exploit the 12X-25X depth range safely.
Sustained-load chip control
Under continuous cutting the internal coolant maintains stable tip temperatures and flushes chips from deep flutes without interruption. The flute geometry resists packing even at maximum 25X depth, preventing torque spikes and premature wear. Cutting edges retain sharpness longer than non-coolant drills in the same alloy groups. Process capability remains predictable across long production batches.
Highlights
- Drill up to 12X-25X diameter depth with coolant-fed design
- Precise 10.30mm cutting diameter for accurate hole sizing
- M.A. Ford Twister XD geometry optimised for demanding drilling applications
- Coolant-fed operation reduces heat buildup during extended drilling cycles
- California Proposition 65 compliance noted for chemical safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck or holder is needed to secure the 10.30mm shank?
The drill has a 10.30mm diameter shank, so a chuck or holder that accepts 10.30mm is required.
Can the 12X-25X coolant-fed drill be used with a standard non-coolant drill press?
It can be used mechanically, but the through-coolant feature will not function without a machine that supplies coolant through the spindle.
How can I verify the 12X-25X drill is cutting correctly after setup?
Check for consistent chip formation, steady feed force, and hole diameter within tolerance at the 10.30mm size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
