M.A. Ford
M.A. Ford 2XDCE2441A Twister XD Drill 12X-25X Coolant Fed 6.20mm
Twister XD drill cuts 12X-25X diameter holes with coolant-fed 6.20 mm shank
- Drills 12 to 25 times diameter for deep holes
- Coolant-fed design clears chips and reduces heat
- 20 mm diameter suits precise metric drilling
- Twister XD geometry extends tool life in tough materials
- California Proposition 65 warning informs safe handling practices
6.20 mm Twister XD Drill
The M.A. Ford Twister XD is a solid-carbide drill with a 6.20 mm diameter. It offers a 12X to 25X diameter drilling depth range through internal coolant channels. The tool is designed for high-performance hole-making in demanding materials.
Machinists needing deep-hole capability
This drill suits CNC operators who require consistent chip evacuation at extended depths. It is not for manual drilling applications or for setups without through-spindle coolant supply. Buyers needing larger diameters or different length ratios should review other options.
12X-25X depth-to-diameter range
The defining specification is the 12X to 25X drilling depth capability enabled by coolant-fed design. This range determines if the tool reaches your required hole depth in a single pass. Verify your machine provides adequate coolant pressure for this specification.
Highlights
- Drills 12 to 25 times diameter for deep holes
- Coolant-fed design clears chips and reduces heat
- 20 mm diameter suits precise metric drilling
- Twister XD geometry extends tool life in tough materials
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 6.20 mm Twister XD drill generate when running continuously at 25X feed?
The drill is designed for high-speed coolant-fed operation; the internal coolant channels evacuate heat directly from the cutting zone so the tool body stays within normal machining temperatures during extended cycles.
What machine setup is required to use the coolant-fed 2XDCE2441A drill?
A CNC or mill spindle with through-coolant capability, a compatible 6.20 mm tool holder, and a coolant system able to deliver the pressure and flow the 12X-25X design expects.
Will the 12X-25X coolant-fed drill fit in the same holder as my older 5X solid-carbide drills?
Yes — the 6.20 mm shank matches standard h6 tolerance, so it clamps in any ER, hydraulic or shrink-fit holder that accepts 6 mm tooling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
