M.A. Ford
M.A. Ford 2XDCE2047A Twister Xd Drill 12X-25X Coolant Fed 5.20Mm
Coolant-fed Twister XD drill operates at 12X-25X with 5.20mm diameter for efficient drilling
- Twister Xd design enables 12X-25X drilling depth
- Coolant-fed operation improves chip evacuation and tool life
- 20 mm diameter suits precise hole-making tasks
- M.A. Ford brand delivers professional-grade cutting performance
- California Proposition 65 warning indicates chemical hazard awareness
M.A. Ford Twister Xd Drill 5.20mm
The M.A. Ford Twister Xd drill is a solid-carbide tool built for high-performance drilling in demanding materials. Its 5.20mm diameter suits precise hole-making in aerospace, automotive and general engineering workshops. The coolant-fed design delivers lubricant directly to the cutting zone for consistent results. This new drill targets machinists who need reliable deep-hole capability.
12X-25X depth range replaces shorter drills
Standard jobber-length drills often cannot reach the depths required by modern component designs. The Twister Xd covers 12 to 25 times diameter in a single pass, reducing cycle time and eliminating the need for peck drilling. The jump is worth it when hole depth exceeds the flute length of conventional tools. Shops drilling shallower holes will not see the same benefit.
Coolant-fed shank fits standard holders
The drill uses a common shank format compatible with ER collets, hydraulic chucks and shrink-fit holders found in most CNC machines. Through-spindle coolant must be active and filtered to prevent blockage in the internal passages. Insufficient coolant pressure or contaminated fluid are the most frequent causes of premature wear. No special adapters are required for typical machining centres.
Highlights
- Twister Xd design enables 12X-25X drilling depth
- Coolant-fed operation improves chip evacuation and tool life
- 20 mm diameter suits precise hole-making tasks
- M.A. Ford brand delivers professional-grade cutting performance
- California Proposition 65 warning indicates chemical hazard awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 5.20 mm Twister Xd drill need for a secure fit?
The 5.20 mm cutting diameter requires a matching 5.20 mm collet or chuck capacity for proper mounting.
How is the coolant-fed Twister Xd drill installed, and what step is often missed?
Insert the drill into the holder, engage the coolant port, then verify coolant flow before starting the 12X to 25X depth cycle.
When should the 2XDCE2047A drill be replaced based on wear?
Replace the drill when the 5.20 mm cutting edges show chipping or when hole tolerance exceeds specification at 12X to 25X depth.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
