M.A. Ford
M.A. Ford 22951180 Twister Al 5X 3 Flute 13.00mm power drill
A 13.00 mm three-flute drill designed for aluminium using the Twister Al 5X geometry
- Twister Al 5X geometry cuts aluminium efficiently
- 3 flute design improves chip evacuation while drilling
- 00 mm diameter matches common hole sizes
- M.A. Ford brand backs professional-grade performance
- New condition delivers full factory specification
13 mm Twister Al 5X drill
The M.A. Ford 22951180 Twister Al 5X is a 13.00 mm three-flute power drill built for aluminium and similar non-ferrous materials. Its geometry targets high material-removal rates in production and maintenance environments.
Capacity and chip evacuation
The three-flute design and 5X helix angle combine to move chips quickly from deep holes, reducing packing and heat in soft alloys. Performance drops when the material hardness exceeds the intended aluminium range or when hole depth approaches the flute length limit.
California Proposition 65 notice
The product carries a California Proposition 65 warning for a chemical known to cause cancer and a chemical known to cause birth defects or other reproductive harm. No accessories or software are bundled with the drill.
Highlights
- Twister Al 5X geometry cuts aluminium efficiently
- 3 flute design improves chip evacuation while drilling
- 00 mm diameter matches common hole sizes
- M.A. Ford brand backs professional-grade performance
- New condition delivers full factory specification
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 13.00 mm Twister Al 5X 3 Flute drill fit the chuck on my older drill press?
The 13.00 mm shank requires a chuck that opens to at least 13 mm; check your press specification before use.
How can I confirm the 22951180 is cutting correctly after I install it?
Look for smooth, chip-free holes in aluminium with minimal vibration and consistent feed resistance.
Does the 22951180 Twister Al 5X 3 Flute drill come with any accessories or must I buy them separately?
The box contains only the 13.00 mm drill bit; cutting fluid, collets or tool holders are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
