M.A. Ford
M.A. Ford 22645670 Twister Gp 3X Drill 11.60Mm pneumatic accessory
Twister GP 3X drill bit, 11.60 mm diameter, for high-performance pneumatic drilling applications
- 60 mm drill diameter suits precise holes
- Twister Gp 3X geometry improves chip removal
- M.A. Ford brand signals professional tool quality
- New condition guarantees full factory performance
- California Prop 65 warning informs safe handling
Product identity
The M.A. Ford 22645670 Twister Gp 3X Drill is a pneumatic accessory with an 11.60 mm cutting diameter. It is intended for professional operators who need a dedicated hole-making tool for metalworking tasks.
Compatibility check
Verify that your pneumatic system can supply the required air pressure and flow for this accessory. Confirm the shank configuration matches your drill chuck or collet before ordering. Buyers who need a different cutting diameter or a non-pneumatic shank style cannot use this item.
Thermals noise and power
In normal use the drill generates heat at the cutting interface and produces noise typical of high-speed pneumatic tools. Power draw depends entirely on the compressed-air supply rather than an electrical rating. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- 60 mm drill diameter suits precise holes
- Twister Gp 3X geometry improves chip removal
- M.A. Ford brand signals professional tool quality
- New condition guarantees full factory performance
- California Prop 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the Twister Gp 3X Drill 11.60Mm come with any extra accessories or must I buy shanks or coolant separately?
The product is supplied as a single 11.60 mm Twister Gp 3X drill bit; no additional shanks, coolant or accessories are included in the package.
Should I choose this 11.60 mm version or a different diameter for my application?
Select the 11.60 mm drill when the hole size required matches that diameter; other diameters are separate part numbers and not interchangeable with this item.
What does the 11.60 mm figure mean once the drill is fitted in a pneumatic tool?
It is the cutting diameter of the bit, so every hole produced will be 11.60 mm wide when the drill is run in a compatible pneumatic driver.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
