M.A. Ford
M.A. Ford 22620080 Twister Gp 3X Drill 5.10mm pneumatic accessory
Twister GP 3X drill bit bores precise 5.10 mm holes in metal and composite materials
- Twister GP 3X design for faster drilling
- 10 mm diameter suits precise hole sizes
- M.A. Ford quality for professional reliability
- New condition ensures full performance life
- Part number 22620080 for easy reordering
Twister Gp 3X Drill 5.10mm
The M.A. Ford 22620080 is a new Twister Gp 3X drill bit sized at 5.10mm. It belongs to the power and pneumatic accessories range and is intended for drilling operations in workshop or industrial settings. Buyers who need a different diameter or a non-pneumatic shank will not be served by this item.
Upgrade considerations
This drill replaces a worn or undersized bit when the application calls for the 5.10mm Twister Gp 3X geometry. The jump is worth it when the existing tool no longer holds tolerance or when the material demands the specific flute design. No other model numbers or generations are referenced in the data.
Installation and common issues
The accessory fits standard pneumatic drill holders that accept the 5.10mm shank. Installation is a direct swap with no additional hardware required. The product carries a California Proposition 65 warning for chemicals known to cause cancer and birth defects or other reproductive harm.
Highlights
- Twister GP 3X design for faster drilling
- 10 mm diameter suits precise hole sizes
- M.A. Ford quality for professional reliability
- New condition ensures full performance life
- Part number 22620080 for easy reordering
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size chuck or collet does the 5.10 mm Twister Gp 3X Drill require?
The drill shank is 5.10 mm, so it fits any standard chuck or collet that accepts a 5.10 mm round shank.
How do I install the Twister Gp 3X Drill in a pneumatic tool, and what step is often missed?
Insert the 5.10 mm shank fully into the chuck, tighten securely, then verify the tool runs true before applying load — skipping the run-out check is the common error.
When will the 22620080 drill need replacement, and what indicates it is worn?
Replace the drill when the cutting edges dull, chip, or the 5.10 mm shank shows excessive wear, which reduces hole accuracy in pneumatic drilling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
