M.A. Ford
M.A. Ford 20745270 Twister Brad & Spur Drill 11.50mm
Twister Brad & Spur Drill cuts clean 11.50 mm holes in wood with precise brad-point accuracy
- Precision drilling with Twister Brad & Spur design
- 50 mm diameter for accurate hole sizing
- M.A. Ford manufacturing for professional reliability
- New condition ensures full cutting performance
- Part number 20745270 for exact replacement ordering
11.50 mm Brad & Spur Drill
The M.A. Ford 20745270 Twister drill bit cuts clean entry holes in wood and composite materials. Its brad point centres the cut while the spur shoulders shear fibres for a splinter-free finish. The 11.50 mm diameter suits cabinetry, joinery and general woodworking tasks. It is supplied new and ready for immediate use.
California Proposition 65 notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. The warning applies to the drill bit itself and does not describe thermal, acoustic or electrical behaviour during drilling. No power-draw or noise figures are provided by the manufacturer.
High-speed steel construction
The bit body is ground from high-speed steel for wear resistance and edge retention in repetitive drilling. A straight shank fits standard three-jaw drill chucks and quick-change adapters without additional sleeves. The Twister flute geometry clears chips efficiently to reduce binding in deep holes.
Highlights
- Precision drilling with Twister Brad & Spur design
- 50 mm diameter for accurate hole sizing
- M.A. Ford manufacturing for professional reliability
- New condition ensures full cutting performance
- Part number 20745270 for exact replacement ordering
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 11.50 mm Twister Brad & Spur Drill 20745270 and what step do people often miss?
Chuck the 11.50 mm shank fully into the drill, tighten securely, and start at low speed to centre the brad point before increasing RPM; the step many miss is verifying the spur is engaged with the wood grain before applying full pressure.
What maintenance or replacement will the 11.50 mm Twister Brad & Spur Drill 20745270 need over time?
The cutting lips and spurs will dull with use; resharpen or replace the bit when hole edges tear or feed force increases noticeably.
What limit appears first on the 11.50 mm Twister Brad & Spur Drill 20745270 during sustained drilling?
Heat buildup at the cutting edges is the first limit; pause periodically to let the 11.50 mm bit cool and clear chips to avoid temper loss.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
