M.A. Ford
M.A. Ford 20725190 Twister Brad Spur Drill 6.40mm pneumatic accessory
A 6.40 mm Twister Brad Spur Drill designed for pneumatic drilling tasks
- 40 mm drill bit suits precise woodworking tasks
- Twister Brad Spur design reduces wandering on entry
- M.A. Ford manufacturing ensures consistent cutting performance
- New condition guarantees full factory sharpness
- Model 20725190 identifies exact replacement for tooling setups
What This Drill Bit Does
The M.A. Ford 20725190 Twister Brad Spur Drill is a 6.40 mm pneumatic accessory designed for precision drilling in wood and similar materials. It suits professional woodworkers and maintenance technicians who need clean entry holes without splintering on through-holes.
Check Your Pneumatic Setup
Verify that your air tool accepts a 6.40 mm shank and delivers the pressure range required for brad-point bits. Confirm the chuck or collet grips this diameter securely so the bit runs true under load.
Heat, Noise and Air Consumption
In normal use the bit runs cool because the cutting geometry evacuates chips efficiently. Noise levels match the pneumatic driver rather than the accessory itself. Air consumption depends on the tool, not the drill bit. California Proposition 65 warnings apply to this product.
Highlights
- 40 mm drill bit suits precise woodworking tasks
- Twister Brad Spur design reduces wandering on entry
- M.A. Ford manufacturing ensures consistent cutting performance
- New condition guarantees full factory sharpness
- Model 20725190 identifies exact replacement for tooling setups
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What is included with the 20725190 Twister Brad Spur Drill and what must be purchased separately?
The box contains the 6.40 mm Twister Brad Spur Drill only. A compatible pneumatic drill motor or chuck is required and sold separately.
Which version of the 20725190 should I choose for my application?
Only the 6.40 mm diameter version is offered under this part number. Select it when you need a 6.40 mm brad-and-spur drill bit.
What does the 6.40 mm figure mean once the drill is in a pneumatic tool?
It is the cutting diameter of the brad-and-spur tip, so each hole drilled will be 6.40 mm wide.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
