M.A. Ford
M.A. Ford 20720100 Twister Brad And Spur Drill No 7 pneumatic accessory
Twister Brad and Spur Drill No 7 creates clean starter holes for precise fastening
- Brad-and-spur tip reduces wandering on wood starts
- Twister flute design clears chips faster during drilling
- Size No 7 fits common fractional-inch hole requirements
- M.A. Ford manufacturing ensures consistent edge geometry
- California Prop 65 warning discloses regulated chemical content
Twister Brad And Spur Drill No 7
The M.A. Ford 20720100 is a Twister Brad And Spur Drill designated No 7 for precision boring tasks. It is built for professional woodworkers and metalworkers who need clean, accurate holes in a variety of materials. This pneumatic accessory delivers reliable performance in demanding workshop environments.
Suited for precision drilling applications
This drill suits users who require a dedicated brad and spur point for accurate hole placement without wandering. It is not intended for general-purpose twist drilling or for driving fasteners. Buyers needing a complete drill bit set or bits for masonry and concrete should look at different tool categories.
California Proposition 65 chemical warning
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users must follow safe handling practices and wear appropriate personal protective equipment. The warning is a regulatory requirement that applies specifically to this item.
Highlights
- Brad-and-spur tip reduces wandering on wood starts
- Twister flute design clears chips faster during drilling
- Size No 7 fits common fractional-inch hole requirements
- M.A. Ford manufacturing ensures consistent edge geometry
- California Prop 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What pneumatic tool is required to drive the Twister Brad And Spur Drill No 7?
The Twister Brad And Spur Drill No 7 is a pneumatic accessory designed for use with a compatible air-powered drill or driver.
Can the Twister Brad And Spur Drill No 7 be used with existing drill chucks on older pneumatic drills?
The Twister Brad And Spur Drill No 7 fits standard chuck sizes found on most pneumatic drills, allowing it to work alongside older hardware.
How can I confirm the Twister Brad And Spur Drill No 7 is cutting correctly after installation?
The Twister Brad And Spur Drill No 7 should produce clean entry holes with minimal splintering when operating properly in wood.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
