M.A. Ford
M.A. Ford 20718110 Twister Brad & Spur Drill 4.60mm pneumatic accessory
Twister Brad & Spur Drill creates clean 4.60 mm holes in wood and plastic
- 60 mm drill diameter for precise holes
- Twister Brad & Spur design cuts cleanly in wood
- M.A. Ford quality for reliable performance
- New condition ensures full tool life
- California Prop 65 warning informs safe handling
Product identity
The M.A. Ford 20718110 Twister Brad & Spur Drill is a 4.60mm pneumatic accessory designed for precision drilling tasks. It is supplied new and ships directly from the manufacturer. This tool suits professional workshops and serious DIY users who need accurate hole placement in wood or composite materials.
Who it suits
Woodworkers and fabricators who require a brad-point tip for clean entry holes and a spur design for reduced splintering will benefit from this drill. It is not intended for buyers who need larger diameter bits, impact-rated shanks, or a multi-piece drill set for varied hole sizes.
Compatibility check
Verify that your pneumatic drill or driver accepts a 4.60mm shank before ordering. Confirm the tool's chuck capacity and collet size match this dimension. Also note the California Proposition 65 warning regarding chemicals known to cause cancer and reproductive harm.
Highlights
- 60 mm drill diameter for precise holes
- Twister Brad & Spur design cuts cleanly in wood
- M.A. Ford quality for reliable performance
- New condition ensures full tool life
- California Prop 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck is needed to hold the 4.60 mm shank of the 20718110 Twister Brad & Spur Drill?
A chuck that opens to at least 4.60 mm will secure the bit; standard 10 mm three-jaw chucks cover this size.
Can the 20718110 Twister Brad & Spur Drill be used in a cordless drill that only accepts 1/4-inch hex shanks?
No, the bit has a 4.60 mm round shank and requires a three-jaw chuck; it will not fit a 1/4-inch hex quick-change holder.
After installing the 20718110 Twister Brad & Spur Drill, how can I confirm it is cutting correctly?
The brad point should centre the hole cleanly and the spurs should score the wood fibres, producing a neat entry with minimal tear-out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
