M.A. Ford
M.A. Ford 16575000 Tuffcut GP 4 Flute Ball Nose End Mill Stub 3/4 pneumatic accessory
Four-flute ball-nose end mill for precision contouring in a compact stub length
- 4-flute ball nose design enables smooth contouring in tight spaces
- Stub length increases rigidity for precise profiling work
- TuffCut GP series delivers reliable performance on general-purpose milling tasks
- 3/4 inch cutting diameter suits a range of standard tooling setups
- New condition ensures full factory specification and cutting life
Industrial milling tool for CNC profiling
The M.A. Ford 16575000 Tuffcut GP is a four-flute ball nose end mill with a stub length. It is designed for general-purpose contouring and profiling in a range of workpiece materials. The solid carbide construction provides rigidity for consistent results in professional machining environments.
Stable cutting under continuous engagement
The four-flute geometry distributes chip load evenly across the cutting edges during sustained profiling passes. This reduces harmonic vibration and helps maintain dimensional accuracy over long tool paths. The stub length minimises deflection when the tool is fully engaged in deep pockets or cavities.
Replaces worn general-purpose ball mills
Shops running dull or lower-flute-count cutters will see improved surface finish and longer tool life. The upgrade is worth it when cycle times are limited by chatter or when finishing passes require tighter tolerances. It is not suited for high-feed roughing strategies that demand specialised variable-pitch geometries.
Highlights
- 4-flute ball nose design enables smooth contouring in tight spaces
- Stub length increases rigidity for precise profiling work
- TuffCut GP series delivers reliable performance on general-purpose milling tasks
- 3/4 inch cutting diameter suits a range of standard tooling setups
- New condition ensures full factory specification and cutting life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much vibration or heat does the 16575000 generate during continuous milling?
The stub-length, four-flute carbide design keeps deflection low, so vibration and heat stay manageable in typical profiling passes.
What tool holder does the 16575000 require to run?
A 3/4 inch shank fits standard ER collets, Weldon flats, or shrink-fit holders matched to your spindle taper.
Will the 16575000 work on an older manual knee mill?
Yes — the straight shank and stub length suit both CNC and manual machines with adequate spindle rigidity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
