M.A. Ford
M.A. Ford 16562500 Tuffcut Gp 4 Flute Ball Nose End Mill Stub 5/8 pneumatic accessory
Four-flute ball-nose end mill in stub length with 5/8 size for precision contour milling
- 4-flute ball nose design enables smooth contour milling
- Stub length provides rigidity for reduced deflection
- Tuffcut GP series built for general-purpose machining
- 5/8 inch shank fits compatible tool holders
- California Prop 65 warning for cancer and reproductive harm
Product identity
The M.A. Ford 16562500 Tuffcut Gp end mill is a four-flute ball-nose cutter with a 5/8 stub length, designed for precision contouring and finishing in milling operations. It is supplied new as a power and pneumatic accessory for professional machining environments.
Intended users and limitations
This tool suits machinists who need a short, rigid ball-nose profile for detailed 3D profiling or radius work in a range of materials. It does not suit buyers who require extended reach, a different flute count, or a larger cutting diameter than the stub configuration provides.
Sustained-load behaviour
The four-flute geometry promotes stable chip evacuation and consistent surface finish during prolonged cutting passes, reducing vibration compared with two-flute alternatives. Heat buildup remains manageable in continuous profiling when appropriate coolant and feed rates are maintained.
Highlights
- 4-flute ball nose design enables smooth contour milling
- Stub length provides rigidity for reduced deflection
- Tuffcut GP series built for general-purpose machining
- 5/8 inch shank fits compatible tool holders
- California Prop 65 warning for cancer and reproductive harm
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What collet size does the 5/8 shank on the 16562500 end mill need?
The 16562500 has a 5/8 shank, so a 5/8 collet or a matching ER collet with a 5/8 bore is required for a secure fit.
Can the 4-flute ball nose on the 16562500 replace a 2-flute cutter on my older mill?
The 4-flute design on the 16562500 gives a finer finish but clears chips slower than a 2-flute; reduce feed rate or use air blast when slotting deep.
How do I verify the 16562500 is cutting correctly after install?
Listen for a steady, low hum and check for a smooth, scallop-free radius on the workpiece; chatter or rough finish means the tool is dull or the holder is loose.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
