M.A. Ford
M.A. Ford 16543750A Tuffcut GP 4 Flute Ball Nose End Mill Stub 7/16 pneumatic accessory
Four-flute ball-nose end mill stub cuts radii and contours in milling operations
- Four-flute design improves chip evacuation and surface finish
- Ball nose profile creates smooth 3-D contours and radii
- Stub length increases rigidity for reduced deflection
- 7/16 inch cutting diameter suits medium milling tasks
- M.A. Ford manufacturing delivers consistent tool performance
7/16 Tuffcut GP ball-nose end mill
This M.A. Ford 16543750A is a 4 flute stub-length ball-nose end mill designed for general-purpose milling in a range of materials. It suits machinists and maintenance teams who need a rigid, short tool for contouring, slotting and pocketing operations.
Sustained cutting stability
The stub length reduces overhang, which helps the tool resist deflection and chatter during extended passes. Four flutes distribute the cutting load evenly, allowing consistent material removal and surface finish when the spindle runs at production feed rates for long periods.
Straightforward holder fitment
The 7/16 shank fits standard collets and end-mill holders without adapters. Ball-nose geometry demands accurate tool-length setting; an incorrect offset is the most common cause of gouged parts or premature tip wear.
Highlights
- Four-flute design improves chip evacuation and surface finish
- Ball nose profile creates smooth 3-D contours and radii
- Stub length increases rigidity for reduced deflection
- 7/16 inch cutting diameter suits medium milling tasks
- M.A. Ford manufacturing delivers consistent tool performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 16543750A end mill generate during continuous cutting?
The tool itself produces negligible heat; most heat comes from the workpiece and spindle interface, so use proper coolant or air blast to manage temperatures.
What tool holder or collet is required to run this 7/16 inch shank end mill?
You need a collet, end mill holder or shrink-fit chuck that accepts a 7/16 inch shank and matches your machine's spindle taper.
Will this 4 flute ball nose cutter work effectively on older manual knee mills?
Yes, it cuts on conventional machines, but lower spindle speeds may require reduced feed rates to avoid chatter and achieve acceptable finish.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
