M.A. Ford
M.A. Ford 16543310 Tuffcut GP 4-flute ball-nose end mill stub 11.0 mm pneumatic accessory
Four-flute ball-nose end mill with an 11.0 mm stub for precision milling tasks
- 4-flute ball-nose design delivers smooth contour milling
- Stub-length geometry increases rigidity for precise shallow cuts
- 0 mm cutting diameter suits standard tool holders
- Tuffcut GP line built for general-purpose machining versatility
- New condition ensures full factory performance from first use
11.0 mm ball-nose end mill
The M.A. Ford 16543310 Tuffcut GP is a four-flute ball-nose end mill with an 11.0 mm cutting diameter. It is designed for general-purpose milling in a variety of materials using CNC or manual machines. The stub length provides increased rigidity for shallow profiling and contouring work.
Four-flute geometry and stub length
The four-flute design offers a balance of material removal rate and surface finish for slotting and profiling operations. The stub length reduces deflection compared to standard-length tools, allowing higher feed rates in shallow cuts. It is not suited for deep-pocket milling where reach exceeds the flute length.
Pneumatic accessory classification
This end mill is categorised as a power and pneumatic accessory for use in compatible tool holders and spindles. It requires a holder capable of securing an 11.0 mm shank with appropriate run-out control. The tool frees up clearance in tight work envelopes where a longer cutter would interfere with fixtures or machine components.
Highlights
- 4-flute ball-nose design delivers smooth contour milling
- Stub-length geometry increases rigidity for precise shallow cuts
- 0 mm cutting diameter suits standard tool holders
- Tuffcut GP line built for general-purpose machining versatility
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 11.0 mm ball-nose end mill fit the collet on my older CNC router?
The cutter has an 11.0 mm diameter; match that size to your collet or use a reducing sleeve for a secure hold.
How can I confirm the 4-flute stub is cutting correctly after installation?
Listen for a steady tone, watch for even chip evacuation and measure the finished radius against the 11.0 mm spec.
Does the 16543310 package include any holders or just the end mill itself?
Only the Tuffcut GP 4-flute ball-nose end mill is supplied; tool holders, collets or coolant accessories must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
