M.A. Ford
M.A. Ford 16539370 Tuffcut GP 4-flute ball nose end mill stub 10.0 mm pneumatic accessory
A 10.0 mm diameter 4-flute ball nose end mill for contoured milling in a stub length
- 4-flute design enables smooth contour cuts
- Ball nose profile creates rounded slots and fillets
- Stub length increases rigidity for heavy feeds
- 0 mm diameter suits medium milling tasks
- California Proposition 65 warning included for safety awareness
M.A. Ford Tuffcut GP ball nose end mill
This 10.0 mm stub-length cutter carries four flutes and a ball nose profile for contouring and finishing in a range of materials. It is supplied new and suits CNC operators and manual machinists who need a rigid, short-reach tool for profiling work.
Prop 65 chemical warning applies
The product carries a California Proposition 65 notice for substances linked to cancer and to birth defects or other reproductive harm. Buyers must follow their shop safety procedures and local regulations when handling or machining with this cutter.
Check shank fit and machine rigidity
Verify that your tool holder or collet accepts the cutter shank and that the machine spindle can run a 10.0 mm four-flute stub tool without excessive deflection. Confirm the workpiece material and coolant strategy match the geometry before ordering.
Highlights
- 4-flute design enables smooth contour cuts
- Ball nose profile creates rounded slots and fillets
- Stub length increases rigidity for heavy feeds
- 0 mm diameter suits medium milling tasks
- California Proposition 65 warning included for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Should I pick the 10.0 mm stub length or a longer flute?
The 10.0 mm stub length gives maximum rigidity for shallow pockets and reduces deflection in tough materials.
How does the 4-flute ball nose geometry perform in a CNC router?
Four flutes leave a smoother finish on contoured surfaces and allow higher feed rates than two-flute tools in steel or aluminium.
What shank standard does the 16539370 end mill use?
It uses a standard 10 mm cylindrical shank that fits ER16 collets and most 10 mm tool holders without adapters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
