M.A. Ford
M.A. Ford 16518750GX Tuffcut GP 4 Flute Ball Nose End Mill Stub pneumatic accessory
Four-flute ball-nose end mill, stub length, model 16518750GX item 03653
- Four-flute design improves chip evacuation
- Ball nose profile creates smooth contoured finishes
- Stub length increases rigidity in tight spaces
- TuffCut GP coating extends tool life
- M.A. Ford quality trusted by professionals
Application & User
The M.A. Ford 16518750GX Tuffcut GP is a 4-flute ball-nose end mill designed for general-purpose milling. It suits machinists and maintenance teams who need a stub-length cutter for profiling and contouring in a variety of materials. The tool is supplied new and carries California Proposition 65 warnings for cancer and reproductive harm.
Sustained Load Behaviour
The four-flute geometry distributes cutting forces across multiple edges, which helps maintain stability during extended passes. Stub length reduces deflection when the tool is engaged deep in a pocket or slot. Carbide construction resists wear so the cutter retains its form through repeated production runs.
Interface Practical Limits
The cutter uses a standard shank that fits common ER collets, Weldon flats or shrink-fit holders. Maximum speed and feed depend on the workpiece material, machine rigidity and holder run-out rather than on the tool alone. Operators must verify holder clamping force and coolant delivery to avoid premature edge chipping.
Highlights
- Four-flute design improves chip evacuation
- Ball nose profile creates smooth contoured finishes
- Stub length increases rigidity in tight spaces
- TuffCut GP coating extends tool life
- M.A. Ford quality trusted by professionals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 16518750GX Tuffcut GP end mill generate noticeable heat or vibration during extended CNC runs?
As a solid-carbide 4-flute ball-nose cutter, the 16518750GX runs cooler than HSS tools when feeds and speeds are matched to the material, and its stub length keeps deflection low so vibration stays minimal during long cycles.
What tool holder or collet size do I need to run the 16518750GX on my mill?
The 16518750GX has a standard shank that fits common ER collets, Weldon flats or shrink-fit holders matching the shank diameter — choose the holder that matches your spindle taper and the cutter’s shank size.
Can I use the 16518750GX alongside older HSS ball-nose cutters in the same job without changing parameters?
Carbide geometry on the 16518750GX allows higher surface speeds than HSS, so you should raise RPM and adjust feed per tooth rather than re-using the same numbers from older cutters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
