M.A. Ford
M.A. Ford 16518750 Tuffcut GP 4 Flute Ball Nose End Mill Stub 3/16 pneumatic accessory
Four-flute ball-nose end mill for stub-length milling in pneumatic setups
- 4-flute design improves chip evacuation for smoother milling
- Ball nose geometry enables precise 3D contouring and finishing
- Stub length increases rigidity for reduced deflection during cuts
- 3/16 inch diameter suits detailed work in tight spaces
- New condition ensures full factory performance and reliability
Product identity and intended use
The M.A. Ford 16518750 Tuffcut GP is a 4 flute ball nose end mill with a stub length and 3/16 size. It is designed for general purpose milling in a variety of materials. The tool suits machinists and fabricators who need a rigid, short flute for contouring and profiling work. Supplied new, it arrives ready for use in compatible tool holders.
Upgrade context
This end mill replaces worn or lower flute count cutters that leave rough finishes on contoured surfaces. The four flute geometry increases feed capability and improves surface quality over two or three flute alternatives. The stub length adds rigidity for shallow pockets where deflection must be minimised. The jump is worth it when cycle time and finish quality outweigh the need for deep reach.
Sustained load behaviour
Under continuous cutting the carbide substrate and coating resist heat buildup better than uncoated high speed steel tools. The short flute length reduces vibration during extended passes in harder alloys. Chip evacuation remains consistent because the stub design keeps chips close to the flute entry point. Operators should monitor tool wear to maintain dimensional accuracy over long runs.
Highlights
- 4-flute design improves chip evacuation for smoother milling
- Ball nose geometry enables precise 3D contouring and finishing
- Stub length increases rigidity for reduced deflection during cuts
- 3/16 inch diameter suits detailed work in tight spaces
- New condition ensures full factory performance and reliability
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size fits the M.A. Ford 16518750 Tuffcut GP 4 Flute Ball Nose End Mill Stub 3/16?
The tool uses a standard 3/16 inch shank that fits any compatible collet or end-mill holder.
How do you install this end mill without causing runout?
Insert the shank fully into the collet, tighten evenly, and verify concentricity before starting the spindle.
When should the M.A. Ford 16518750 end mill be replaced?
Replace it when the ball-nose cutting edges show visible wear, chipping, or when surface finish degrades.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
