M.A. Ford
M.A. Ford 16515620GX 3/32 2 Flute Stub Ticn pneumatic accessory
A 3/32-inch, two-flute stub end mill with TiCN coating for pneumatic milling applications
- 3/32 inch diameter suits fine-detail pneumatic work
- Two-flute stub design increases rigidity in tight spaces
- TiCN coating extends tool life under high heat
- M.A. Ford manufacturing ensures consistent cutting geometry
- California Proposition 65 warning discloses regulated chemical content
3/32 2 Flute Stub Ticn Accessory
The M.A. Ford 16515620GX is a new pneumatic accessory designed for precision machining tasks. It features a 3/32 size with a two-flute stub configuration and a Ticn coating for enhanced wear resistance. This component suits workshops requiring reliable cutting performance in power tool applications.
Machinists needing coated stub cutters
This accessory fits operators who need a small-diameter, two-flute tool with a Ticn finish for specific milling or drilling jobs. It is not suited for buyers who require a larger cutting diameter or a different flute count for their application. Shops without pneumatic power tool systems should look at alternative tooling types.
Integrates with pneumatic power tools
The accessory mounts directly into compatible collets or chucks on pneumatic equipment, requiring no additional adapters beyond standard tool-holding hardware. Its stub length frees up clearance in tight work envelopes where longer tools would interfere. The Ticn coating reduces the frequency of tool changes by extending edge life during production runs.
Highlights
- 3/32 inch diameter suits fine-detail pneumatic work
- Two-flute stub design increases rigidity in tight spaces
- TiCN coating extends tool life under high heat
- M.A. Ford manufacturing ensures consistent cutting geometry
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size collet or chuck do I need to hold the 3/32 shank on the M.A. Ford 16515620GX?
Use a 3/32 inch collet or chuck that matches your pneumatic tool's spindle; the cutter's shank is ground to that diameter for a secure fit.
Will the TiCN coating on this stub-length cutter hold up when I run it in my older air die grinder at typical shop RPM?
The TiCN coating resists heat and wear at normal die-grinder speeds, and the stub length reduces deflection even on higher-vibration tools.
How can I confirm the 16515620GX is cutting cleanly after I install it?
Check for consistent chip formation, minimal burrs on the workpiece, and no chatter marks — these show the flute geometry and coating are performing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
