M.A. Ford
M.A. Ford 16511810 Tuffcut GP 4 Flute Ball Nose End Mill 3.0mm
A 4-flute ball-nose end mill with a 3.0 mm diameter for contour milling
- 4-flute design enables smooth contour milling
- Ball nose profile produces precise 3D radii
- Stub length increases rigidity for accurate cuts
- 0 mm diameter suits fine-detail machining
- M.A. Ford quality delivers reliable tool life
M.A. Ford 3.0 mm ball nose end mill
This M.A. Ford 16511810 Tuffcut GP end mill is a 3.0 mm diameter cutter with four flutes and a ball nose profile. It is supplied new and intended for general-purpose milling in a range of materials. The stub length reduces overhang for increased rigidity during cutting operations. Machinists and maintenance teams use it for profiling, slotting and contouring work.
Four-flute carbide construction for rigidity
The four-flute design provides a strong core that resists deflection under load, while the ball nose geometry creates smooth radii and contoured surfaces. A standard shank fits common ER collets, Weldon flats and hydraulic holders found in most workshops. The stub format keeps the cutting length short, which improves stability when the tool is clamped in a holder.
Check shank diameter and holder compatibility
Before ordering, verify that your machine spindle or tool holder accepts the shank diameter of this 3.0 mm cutter. Confirm the available stick-out suits the stub length for the depth of cut you plan to machine. Ensure your workpiece material and coolant strategy match the uncoated carbide substrate. California Proposition 65 warnings apply to this product.
Highlights
- 4-flute design enables smooth contour milling
- Ball nose profile produces precise 3D radii
- Stub length increases rigidity for accurate cuts
- 0 mm diameter suits fine-detail machining
- M.A. Ford quality delivers reliable tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 3.0 mm Tuffcut GP end mill use?
The cutter has a 3.0 mm cutting diameter and a matching 3.0 mm shank, so it fits any 3 mm collet or chuck.
How long is the flute section on this stub-length tool?
The stub design keeps the flutes short — typically about 4 to 5 mm — for maximum rigidity in shallow pockets.
Which step do users often skip when installing this end mill in a collet?
Clean both the shank and collet bore thoroughly, then tighten the collet nut to the holder's specified torque; a dirty or loose fit causes run-out and premature wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
